Cold-start plenum with SD throttle body
Thread Starter
Member
iTrader: (1)
Joined: Jul 2006
Posts: 129
Likes: 0
From: Stoughton, MA
Engine: 5.7 vortec crate w/TPI
Transmission: 2004r
Axle/Gears: 3.42
Cold-start plenum with SD throttle body
I have a complete SD setup on my car, and when I was pulling it apart last week I snapped a seized bolt in my plenum.
I have an older MAF plenum lying around, as well as a set of TPiS cold-start large tube runners (The reason why I was pulling my TPI setup apart in the first place). Would it be ok to run the TPiS runners (With a cold-start blockoff), the cold-start plenum, and the SD throttle body together, or would I run into problems?
I have an older MAF plenum lying around, as well as a set of TPiS cold-start large tube runners (The reason why I was pulling my TPI setup apart in the first place). Would it be ok to run the TPiS runners (With a cold-start blockoff), the cold-start plenum, and the SD throttle body together, or would I run into problems?
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
Jun 13, 2021 01:13 PM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM
