Hey guys, i need to replace the send line from tank to filter. Where can i find replacement ? BTW, I have '86 LB9 engine. Thanks.

 

Anyone ?

 

Should be able to just buy a length of fuel line (rubber/synthetic) from your local autozone/advance/etc, cut it to length and replace it.

 

check this to see if any apply.http://www.thirdgenranch.com/catalog/category/5353654

 

This is for a TPI setup. Theres a hard line from tank then compression fitttings w/rubber line (date coded) then back to a hard line to filter (?).

Any suggestions ?

 

Try a wrecking yard.

 

Call up the guys at www.thirdgenranch.com I think they have some

 

Cut the hard lines at the tank and at the filter. Leave 2-3" so you can connect a new rubber hose. Buy Fuel Injection hose, and install using Fuel Injection hose clamps. Use two clamps on each end for safety. If you really want to get fancy, there is a tool that will allow you to "roll" a hose bump into the line. Not really necessary, but just more info.

http://autoplicity.com/products/1379...FURsfgodvW0AfA

 

This is what the line looks like. Flare goes to filter rubber lune to tank. Im not hacking this up this is a date coded factory correct piece.

 

I just went through the same thing. I had to buy the new metal line from http://www.getdiscbrakes.com/fgl8507 . Then I made a short hose to replace the rubber part with an lines and fittings.

 

inline tube