Name that Lever!!!
Thread Starter
Supreme Member
iTrader: (3)
Joined: May 2004
Posts: 2,233
Likes: 4
From: stockton, CA
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
Name that Lever!!!
Im doing a shift kit and i think i broke this lever. Can you tell me what it is PLZ
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
You've got the shifter cable circled there. The lever it attaches to could go by several names. Shift lever? Manual shaft lever? Selector lever?
Thread Starter
Supreme Member
iTrader: (3)
Joined: May 2004
Posts: 2,233
Likes: 4
From: stockton, CA
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
Thanks alot bro. Im going to have to buy a new one. Have you ever installed one before? Does it run to the shifter ***?
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
It's pretty easy to replace. The cable runs from the bracket on the transmission through a grommet in the floor to the shifter. It might take a few tries to get it adjusted properly, but it's not that big of a deal.
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
If you have the the shifter and the transmission in neutral whene you tighten the nut that attaches the cable to the slotted lever it should be properly adjusted, but sometimes things like to move when you tighten the nut so it might take a couple of tries.
Thread
Thread Starter
Forum
Replies
Last Post
wigmobile
Electronics
5
Feb 26, 2025 02:56 PM