Shifting problems at track
Thread Starter
Supreme Member
Joined: Mar 2005
Posts: 1,665
Likes: 3
From: Benzie, MI
Car: 91 rs
Engine: Blow through 383, 10 psi, xr288hr
Transmission: Manual th350 ATI 3000
Axle/Gears: 3.50 9"
Shifting problems at track
The last two times I've been to the track, I seemed to have missed a gear. I launch out of the hole, shift, and I'm in third. Going down the back stretch it has all gears. Since the first time it happened, I made sure that my hand was off the shifter when launching and that I was actually leaving in first.
The very last run I did, it shifted fine and def launched in first. The other times it was either leaving in second or shifting to second on its own very quickly. I'm really confused.
Something violent occurred in the driveline when I let off the gas in the burnout box too, but this was after the shifting problem.
Its a reverse full manual th350, no transbrake.
The very last run I did, it shifted fine and def launched in first. The other times it was either leaving in second or shifting to second on its own very quickly. I'm really confused.
Something violent occurred in the driveline when I let off the gas in the burnout box too, but this was after the shifting problem.
Its a reverse full manual th350, no transbrake.
Thread Starter
Supreme Member
Joined: Mar 2005
Posts: 1,665
Likes: 3
From: Benzie, MI
Car: 91 rs
Engine: Blow through 383, 10 psi, xr288hr
Transmission: Manual th350 ATI 3000
Axle/Gears: 3.50 9"
Re: Shifting problems at track
No ideas?
I'm planning on replacing the blower with a 250+ shot of nitrous out of the hole which should be a real strain for the trans.
I'm planning on replacing the blower with a 250+ shot of nitrous out of the hole which should be a real strain for the trans.
Thread
Thread Starter
Forum
Replies
Last Post
dhonda200
Transmissions and Drivetrain
6
Aug 11, 2015 11:50 PM




