V6 Discussion and questions about the base carbureted or MPFI V6's and the rare SFI Turbo V6.

Blinker?

Thread Tools
 
Search this Thread
 
Old Mar 30, 2004 | 08:06 PM
  #1  
camaro350man's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2004
Posts: 920
Likes: 0
From: Belchertown MA
Car: 1988 Pontiac Firebird
Engine: 2.8 Lt
Transmission: 5 Spd
Blinker?

Hey guys. Another prob now. When i click my blinker the light doesn;t flash inside the car like it used to. It just stays lit and the outside lights also don't work. When i turn my headlights on the blinker stays lit inside and does not flash outside. But when the lights are on its always lit even if i push the switch down. But with the headlights off it doesn't, it will shut off. Someone said i have a bulb out, what do you guys think? Dangerous to drive now
Reply
Old Mar 30, 2004 | 08:17 PM
  #2  
TechSmurf's Avatar
Supreme Member
 
Joined: Dec 2000
Posts: 2,375
Likes: 0
From: Tucson, AZ, USA
Car: '99 Trans Am, '86 Camaro
Engine: LS1, Scrap
Transmission: T56, T5
Axle/Gears: 3.42 Stock ZT, 3.42 Open
That would be a toast bulb or two.
Reply
Old Mar 30, 2004 | 08:23 PM
  #3  
camaro350man's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2004
Posts: 920
Likes: 0
From: Belchertown MA
Car: 1988 Pontiac Firebird
Engine: 2.8 Lt
Transmission: 5 Spd
So what do i do to find out? Do I have to rip the dash apart and just look at all of them? Any idea on what lights it could be?
Reply
Old Mar 30, 2004 | 08:47 PM
  #4  
RedTtop5spd's Avatar
Member
iTrader: (1)
 
Joined: Feb 2004
Posts: 274
Likes: 0
From: Florida
Car: 99 SS
Engine: LS1
Transmission: T56
Try the outside blinker lights. Should be one of them.
Reply
Old Mar 30, 2004 | 09:00 PM
  #5  
camaro350man's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2004
Posts: 920
Likes: 0
From: Belchertown MA
Car: 1988 Pontiac Firebird
Engine: 2.8 Lt
Transmission: 5 Spd
They work with the hazards on, could it still be that.
Reply
Old Mar 31, 2004 | 12:19 AM
  #6  
85f-bird's Avatar
Supreme Member
 
Joined: Mar 2000
Posts: 2,028
Likes: 0
From: St. Louis, MO
Car: 85' Firebird (Project), 92' RS
Engine: 2.8L, LS1
Transmission: 700R4, 4L60E
Axle/Gears: 3.42 Open , 10 Bolt (ukn)
It's an outside marker bulb, check ur front headlight markers, and also check the corners. Essentially ,it's saying that they're not blinking, just staying on, and they're supposed to go between bright and nada, or bright and not so bright. Give it another try, and also try it w/ ur parking lights on and off....see if theres a difference.
Reply
Old Mar 31, 2004 | 02:22 PM
  #7  
camaro350man's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2004
Posts: 920
Likes: 0
From: Belchertown MA
Car: 1988 Pontiac Firebird
Engine: 2.8 Lt
Transmission: 5 Spd
Thanks guys, ya it was my front marker light. Never knew that it could affect that much. Learning something new everyday. Thanks guys.
Reply
Old Apr 2, 2004 | 10:47 AM
  #8  
TomP's Avatar
Supreme Member
 
Joined: Mar 2000
Posts: 13,414
Likes: 6
From: Central NJ, USA
Car: 1986 Firebird
Engine: 2.8 V6
Transmission: 700R4
This isn't on topic, but a quick FYI- my blinkers were really S-L-O-W... usually that means a dying battery/alternator/etc, but all my stuff was in top condition.

The blinker can was just worn out! A new one fixed the problem ($3)- I think I had to replace it around 215,000 miles? So I was going nuts tracing an electrical problem that didn't exist...
Reply
Old Apr 2, 2004 | 10:51 PM
  #9  
85f-bird's Avatar
Supreme Member
 
Joined: Mar 2000
Posts: 2,028
Likes: 0
From: St. Louis, MO
Car: 85' Firebird (Project), 92' RS
Engine: 2.8L, LS1
Transmission: 700R4, 4L60E
Axle/Gears: 3.42 Open , 10 Bolt (ukn)
hey tom, do ya have a better description of a blinker can? just kinda curious i've got a slow blinker setup.
Reply
Old Apr 6, 2004 | 05:44 PM
  #10  
Pyroja's Avatar
Junior Member
 
Joined: Oct 2003
Posts: 36
Likes: 0
From: NorCal
Car: None! =(
Engine: My own two feet.
Transmission: My, uh.. Knees?
I have a smilar problem.. My blinkers just decided to stop working. Even the blionker lights inside the car don't light up. But only if I use the turn signal lever thing. if I kick on the hazard lights, they all light up and flash just fine. So I'm uh.. Confused?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
RABMAN
Interior Parts Wanted
2
Sep 18, 2015 09:02 PM
Jk_Under
Electronics
3
Sep 2, 2015 10:59 PM
bklucas12
Tech / General Engine
3
Jan 11, 2002 06:44 AM
super83Z
Electronics
2
Jun 2, 2001 10:44 AM
Jimmy91RS
Electronics
2
Sep 28, 2000 02:16 PM




All times are GMT -5. The time now is 12:23 AM.