new to 3rd gen camaro need big help
new to 3rd gen camaro need big help
just got my 2nd camaro well it is a 88 2.8 auto well it needed a fuel pump and tank well got both installed andn ow the car will start and rev to 70? then shut off it will stay on if i fluter the gas but soon as i let go it shuts off any ideas
Senior Member
iTrader: (2)
Joined: Jun 2008
Posts: 728
Likes: 0
From: Traverse City, MI
Car: 91' Firebird
Engine: 3.1 LH0 V6
Transmission: Auto 700R4
Axle/Gears: 3.23 limited slip
Re: new to 3rd gen camaro need big help
I re-read this 3 times and still can't figure out what the car's doing... Anyone else?
Member
Joined: Apr 2011
Posts: 113
Likes: 0
From: Dinwiddie VA
Car: 1986 Camaro Z28
Engine: 5.0 305 TPI
Transmission: 700R4
Axle/Gears: posi 3.73
Re: new to 3rd gen camaro need big help
best i can see is replaced fuel pump and tank and now it will start rev upto 7000 rpm then shut off unless they keep their foot on the gas pedal so i want to say it sounds like a TPS or timing issue
Re: new to 3rd gen camaro need big help
sorry i was up for 36 hours when i typed that well i replaced the tank and pump and barrery well it starts but will rev to 7000 and shut off if i give it gas it will run till i left off the gas
Senior Member
Joined: Feb 2009
Posts: 601
Likes: 0
From: Jacksonville FL
Car: 1988 camaro
Engine: cammed 3.1
Transmission: 700r4
Axle/Gears: 10 bolt 3.42
Re: new to 3rd gen camaro need big help
First off are you getting a check engine light? There could be a number of things causing your problem. You could have a really bad vacuum leak so check all the vacuum lines see if any are broken or disconnected. You could also check the TPS with a digital multi meter, key on engine off it should read .54 volts with the throttle closed and the voltage should climb smoothly as you open the throttle by hand if it jumps around when the throttle isn't moving then you have a bad TPS sensor. Check the IAC valve to see if there is junk clogging the hole where it goes in and spray some carb cleaner to clean it up some if it looks dirty.
Trending Topics
Senior Member
Joined: Feb 2009
Posts: 601
Likes: 0
From: Jacksonville FL
Car: 1988 camaro
Engine: cammed 3.1
Transmission: 700r4
Axle/Gears: 10 bolt 3.42
Re: new to 3rd gen camaro need big help
If your looking at the engine from the front of the car its on top left side of the throttle body. It has a square 4 wire connector going to it.
Joined: Mar 2006
Posts: 4,367
Likes: 15
Car: 1973 Datsun 240Z/ 1985 S-15 Jimmy
Engine: Turbo LX9/To be decided
Transmission: 5-speed/T-5
Axle/Gears: R200 3.90/7.5" 3.73
Re: new to 3rd gen camaro need big help

I'm not sure why you'd be revving, an assumed to be stock, 2.8L to 7000 RPM. They don't really make power beyond 5000 under load and 7000 RPM free revs aren't a very good thing for the engine.
If it's stalling, then there are things to check, like the IAC, closed throttle position, fuel pressure, timing, etc.
Senior Member
iTrader: (2)
Joined: Jun 2008
Posts: 728
Likes: 0
From: Traverse City, MI
Car: 91' Firebird
Engine: 3.1 LH0 V6
Transmission: Auto 700R4
Axle/Gears: 3.23 limited slip
Re: new to 3rd gen camaro need big help
7K has got to be over redline, no way a TPS could cause the engine to rev that high. Do you have your foot on the gas when your starting it? or are you saying it's reving that high by itself?
Re: new to 3rd gen camaro need big help
ayez i wunt help wit me car but u guys bother me bout grmmer
I'm a bit of a grammar freak myself, but it's kind of annoying to see this thread turn to that. I understood what he said just fine.
He said his oven overheated to 7,000 degrees, and now he needs a new bag of french fries. Also, he said that if he plays his flute, the gas prices go up.
Everyone good now? Alright then.
I'm a bit of a grammar freak myself, but it's kind of annoying to see this thread turn to that. I understood what he said just fine.
He said his oven overheated to 7,000 degrees, and now he needs a new bag of french fries. Also, he said that if he plays his flute, the gas prices go up.
Everyone good now? Alright then.
Senior Member
Joined: Feb 2009
Posts: 601
Likes: 0
From: Jacksonville FL
Car: 1988 camaro
Engine: cammed 3.1
Transmission: 700r4
Axle/Gears: 10 bolt 3.42
Senior Member
iTrader: (2)
Joined: Jun 2008
Posts: 728
Likes: 0
From: Traverse City, MI
Car: 91' Firebird
Engine: 3.1 LH0 V6
Transmission: Auto 700R4
Axle/Gears: 3.23 limited slip
Re: new to 3rd gen camaro need big help
ayez i wunt help wit me car but u guys bother me bout grmmer
I'm a bit of a grammar freak myself, but it's kind of annoying to see this thread turn to that. I understood what he said just fine.
He said his oven overheated to 7,000 degrees, and now he needs a new bag of french fries. Also, he said that if he plays his flute, the gas prices go up.
Everyone good now? Alright then.
I'm a bit of a grammar freak myself, but it's kind of annoying to see this thread turn to that. I understood what he said just fine.
He said his oven overheated to 7,000 degrees, and now he needs a new bag of french fries. Also, he said that if he plays his flute, the gas prices go up.
Everyone good now? Alright then.
Thread
Thread Starter
Forum
Replies
Last Post
I'llrocya
Interior Parts for Sale
3
Feb 2, 2016 11:43 PM
Zachattack0925
Tech / General Engine
2
Aug 12, 2015 09:54 PM
Zachattack0925
Transmissions and Drivetrain
4
Aug 12, 2015 09:52 PM









