Cruise control and brake switch question

Reply Subscribe

Thread Tools

Search this Thread

04-29-2013, 08:48 PM

pimpimusmaximus

Member

Thread Starter

Join Date: Aug 2010

Location: San Antonio

Posts: 230

Likes: 0

Received 0 Likes on 0 Posts

Car: 1984 Z28 T-TOP

Engine: 355 Lt1 w/Hotcam

Transmission: TH700R4

Axle/Gears: 3.73 4th gen limited slip

Cruise control and brake switch question

I am working on installing a TCC lockup kit. I am looking at the two switches at the brake pedal. One has 2 wires and has a vacuum hose on the back of it. I think this is the cruise control brake cut off switch. The other has 2 connectors 1 with 2 wires and the other with 3 wires. I think this is the brake switch for lights and the TCC switch.

Here is my question.....
The manual says the brake switch is a pink/black and purple wire, but it is on the cruise control switch, not the brake switch. Is it possible that the two 2 wire connectors were put on the wrong switch? They look as if they would fit, ie. same clip for the wires. I know either would work, but the cruise control switch is broken and I am not using cruise right now. The other 2 wire connector has thick light blue and orange wires, but I can't find reference for those two wires.

Reply Like

05-06-2013, 07:36 AM

NINÅ

Supreme Member

Join Date: Jan 2006

Location: Mooresville NC

Posts: 3,341

Likes: 0

Received 10 Likes on 10 Posts

Car: LOWERED ♦ CRIMSON METALFLAKE

Engine: ► 400 KUBES ◄

Transmission: 765R4

Axle/Gears: EATON POSI 4.56

OK Team, Take A Brake

To find out which switch is which, press one at a time by hand, while backed up near your garage or other reflective surface which can show when the brake lights are illuminated.

◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙

Spin Me This Week . . . I’ll Spin You Next Week