cal30_sniper

iTrader: (16)

Hey all,

I just finished switching all of my brand new cooling system from my 350 Suburban to the 454, and the water pump does not interchange between the small block and big block. It's a Milodon High-Volume pump with only 12k miles on it. I installed it last summer to help keep the beast cool towing my boat and everything I owned down to Texas in the middle of August. It kept it below 165 degrees the entire way (at 70-75 mph in 100+ degree heat), and I had it weighed in at the truck stop at 11,000 lbs with the trailer.

In my opinion, its the best waterpump out there for the cost. I'm running one on my 454 too. The only other pump I trust is the Edelbrock 8881, which is what I have on my GTA. These are very sturdily built, and it made a big difference over stock in cooling. It runs $89 new from Summit http://www.summitracing.com/parts/MIL-16213/. I'm asking $45 plus the ride.

I installed it after doing a double system flush with Peak Radiator Flush. After the flush, I drained ALL coolant from the engine until it was running straight distilled water. I then added the proper amount of concentrated Peak Lifetime Antifreeze to bring it up to a 50/50 mixture over the complete system (complete capacity given by the factory service manual). I also added Water Wetter additive for the seals. The motor it was on only had 30k on it (the pump went on at the same time that I put the Vortec heads on, and it was clean as a whistle inside). There's still a huge amount of life in the pump, I'd say it's barely broke in.

I'll mark it as soon as it's sold.



-cal30sniper

In case you didn't click on the link, this is a reverse rotation water pump for an '88-up Serpentine Belt system small block.

cal30_sniper

iTrader: (16)

Things that go bump in the night...

Summer's here. Somebody might really need this to help keep you cool through the heat.

-cal30sniper

cal30_sniper

iTrader: (16)

Bump again...

evilemokid94

iTrader: (6)

ill take that intake off your hands thats in the picture . bump for ya on the waterpump though

cal30_sniper

iTrader: (16)

Thanks for the bump! I'll get the intake listed eventually. Right now, it's only purpose is to keep the elements out of my engine. That's the 35k mile 350 Vortech motor out of my '90 Suburban. It's going on an engine stand for a year or two until I get the time to drop it underneath a high-flow TPI setup with a mild roller cam in the GTA.

evilemokid94

iTrader: (6)

looks like an aftermarket peice. I'm trying to find a carb intak for my vortec build for the camaro

cal30_sniper

iTrader: (16)

Bump.

mikesprojectZ

how about we do 55 shipped to 17603??

cal30_sniper

iTrader: (16)

Let me get a quote for you tomorrow and I'll shoot you a PM about it.

mikesprojectZ

okay, i will be on later tonight you can pm me and let me know.

cal30_sniper

iTrader: (16)

Bump. MikesprojectZ quit responding, so it's still available.

Drkhrse89

iTrader: (1)

Could you PM a price, plus the ride, to 55379?

cal30_sniper

iTrader: (16)

Bump, still have this thing.