Slick89RS

iTrader: (1)

So I've been missing for quite a while on this board. (Married, kid, house, remodeling etc. )
I finally pulled the Camaro out of almost four years of storage and fixed all sorts of small things.
Then I felt with having the 70mm Turbo online it was time to ditch the Cobbled together exhaust I hade before for some 4"

The system is comprised od a few U / J bends, one straight piece, a left over diesel muffler, and a 3 - 4" adapter.

I figured I could throw it up here and just mention its really not too hard to make.

Orr89RocZ

iTrader: (20)

Turbos like bigger exhaust looks good

hellz_wings

iTrader: (2)

That 4" actually is probably lighter than the old one.

padak

iTrader: (10)

Wanna sell those exhaust tips?

LastGTA

iTrader: (1)

Make me one, I'll provide the muffler and pick it up.

Slick89RS

iTrader: (1)

Bring me the car and the muffler i'll do it in on a saturday

The only reason I say bring the car is cause its such a tight fit and I don't want to take my exhaust off just to match it.

Keoman

iTrader: (3)

So you welded that on the floor and somehow managed to snake it over the axle in the car? If so I'm impressed.

Twin_Turbo

iTrader: (25)

it looks like there is a slip fit connection where it kicks up in front of the axle

Slick89RS

iTrader: (1)

Spot on there.

You can see where the pipe is "buffed" at the weld joint just before the axle that's where the slip fit is.

Javier87z28

iTrader: (1)

Looks nice take a vid of how it sounds!

RS/SS 4.8

iTrader: (1)

Do you think you can make me one without muffler (straightpipe)?

Slick89RS

iTrader: (1)

I'll try this weekend. Its actually pretty quiet due to the turbo.

Your the third person to ask me that. If I get a few more maybe I'll make a weekend out of it and build a few systems.

Dirt cheap of course compared to mufflex

RS/SS 4.8

iTrader: (1)

Heck yea. If u decide to do it put me on the list.

Keoman

iTrader: (3)

Where did you acquire your tubing? Approximate cost?
Thanks

LastGTA

iTrader: (1)

Awesome, I will have to bring it next spring. The car is currently in the process of an LS swap.

Orr89RocZ

iTrader: (20)

Hawks makes a 4" catback you can adapt to a thirdgen. No muffler, over axle and dumped..and 400$ for it

Slick89RS

iTrader: (1)

I would have to look up all the parts I used again.

Also, I have a wholesale tire and exhaust supplier. So what I pay and what you can get it for might be a bit different.

bvahnee

iTrader: (2)

Also interested in a setup if you decide to make a few. Ive got a 454 single turbo that right now kicks out behind the front tire. Ive got some a long straight piece already so I would really only need the bit from just past the straight to the back + a very quiet muffler.

If its prices around a couple hundred for just that I'd be a buyer ASAP.

bvahnee

iTrader: (2)

http://item.mobileweb.ebay.com/viewi...d=380527342884

For the OP, this may be a good kit to start with then modify for the third gens on the cheap. I just ordered one to see how much modding it'll need. I'll keep you informed.