No injector pulse
#1
No injector pulse
Im trying to wire up an 89 tpi ina fiero with a 355 i have spark, and the vats has been supposedly taken off the chip, but the injectors have no pulse and have voltage on both sides. Any ideas?
#2
Supreme Member
iTrader: (8)
Join Date: Oct 2001
Location: Il
Posts: 11,732
Received 787 Likes
on
528 Posts
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: No injector pulse
What harness are you using? Did u check your 2 inj fuses?
#4
Senior Member
Join Date: Jul 1999
Location: Everett, MA . USA
Posts: 853
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 FORMULA FIREBIRD, 86 CHEVY CAMARO
Engine: L98, LB9 RESPECTIVLY
Transmission: 700 R4 (BOTH)
Re: No injector pulse
Check for a bad pickup coil and/or ignition module either will cause a no pulse condition.
also check the bulkhead connector on the firewall to make sure it does not need to be repinned.
also check the bulkhead connector on the firewall to make sure it does not need to be repinned.
#7
Member
Join Date: Sep 2010
Location: NE Ohio
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
Car: 84 z28
Engine: 305 for now, lil more then stock
Transmission: 700r4 for now
Re: No injector pulse
If your sure vats was elemenated then might start with ign module it uses the ground side to pulse injectors sence you have pwer trace the ground
Trending Topics
#9
Member
Join Date: Sep 2010
Location: NE Ohio
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
Car: 84 z28
Engine: 305 for now, lil more then stock
Transmission: 700r4 for now
Re: No injector pulse
Pickup coil would be spark side for plugs so thats probly ok ign module would be pulse side for injectors i would start there check for loose connectors crimped wireing and all the basic fuses/relays ect
Thread
Thread Starter
Forum
Replies
Last Post