Go Back   Third Generation F-Body Message Boards > Tech Boards > Transmissions and Drivetrain
Sign in using an external account
Register Forgot Password?

Transmissions and Drivetrain Need help with your trans? Problems with your axle?

Welcome to ThirdGen.org!
Welcome to ThirdGen.org.

You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!


Reply
 
Thread Tools Search this Thread
Old 11-05-2009, 07:52 PM   #1
Junior Member
 
bjm1206's Avatar
 
Join Date: Aug 2009
Posts: 88

Classifieds Rating: (0)
is my drive shaft bad or my trans

Ok at about 50-55 my car starts shaking like no other, it feels ok until i hit 55. Any ideas what this may be. I also would like to add I replaced the u joints. And while I had the drive shaft off the PO had hose 2 hose clamps near the trans. I dont know what this is about, may be a cheap balance act. any ways i took them off, it didnt seem to make a difference.
bjm1206 is offline vBGarage Page   Reply With Quote
Old 11-05-2009, 09:35 PM   #2
Senior Member
 
Iroc-Z28Man's Avatar
 
Join Date: Sep 2009
Location: Lower Burrell, Pa
Posts: 323
Car: 86 Iroc-Z28 Camaro/84 BMW M Power
Engine: 350TPI/ S50
Transmission: t-5 five speed/ 5 speed
Axle/Gears: 3.42 posi/ 3.90

Classifieds Rating: (0)
Re: is my drive shaft bad or my trans

Most likey cause is the tires are out of balance, i wouldn't suspect the tranny going bad inless it is making noise or shifting funny. It could also be that the driveshaft is bend or out of balance. Have you hit any pot holes/speed bumps to fast or run over anything to aggresively?
__________________
"Speed has never killed anyone, suddenly becoming stationary... that’s what gets you.”-Jeremy Clarkson ,TopGear
Iroc-Z28Man is offline vBGarage Page   Reply With Quote
Old 11-05-2009, 10:15 PM   #3
Junior Member
 
bjm1206's Avatar
 
Join Date: Aug 2009
Posts: 88

Classifieds Rating: (0)
Re: is my drive shaft bad or my trans

no i have not hit anything hard and the wheels and tires are brand new they only have like 30 miles on them
bjm1206 is offline vBGarage Page   Reply With Quote
Old 11-05-2009, 10:18 PM   #4
Senior Member
 
Iroc-Z28Man's Avatar
 
Join Date: Sep 2009
Location: Lower Burrell, Pa
Posts: 323
Car: 86 Iroc-Z28 Camaro/84 BMW M Power
Engine: 350TPI/ S50
Transmission: t-5 five speed/ 5 speed
Axle/Gears: 3.42 posi/ 3.90

Classifieds Rating: (0)
Re: is my drive shaft bad or my trans

Did this shaking happen before or after the new tires?
__________________
"Speed has never killed anyone, suddenly becoming stationary... that’s what gets you.”-Jeremy Clarkson ,TopGear
Iroc-Z28Man is offline vBGarage Page   Reply With Quote
Old 11-05-2009, 10:28 PM   #5
Senior Member
 
berlin305's Avatar
 
Join Date: Dec 2007
Location: Belleville, KS
Posts: 533
Car: 1986 camaro coupe
Engine: 305 v8 HO, edlebrock carbed
Transmission: Borg Warner WC T5
Axle/Gears: what ever came with these cars

Classifieds Rating: (2)
Send a message via MSN to berlin305
Re: is my drive shaft bad or my trans

Its the u joints. You will need to replace. Try this when you put it in gear do you hear kind of a faint clunk in the rear end? and when you drive it vibrates not constant but high vibration to low vibration if it does this. The u joints need to be replaced. I had the same problem.
__________________
Owner of http://kansastgo.49.forumer.com/index.php

1986 camaro Coupe 305 V8 HO
WC T5
Rearend stock
berlin305 is offline vBGarage Page   Reply With Quote
Old 11-05-2009, 10:39 PM   #6
Senior Member
 
Iroc-Z28Man's Avatar
 
Join Date: Sep 2009
Location: Lower Burrell, Pa
Posts: 323
Car: 86 Iroc-Z28 Camaro/84 BMW M Power
Engine: 350TPI/ S50
Transmission: t-5 five speed/ 5 speed
Axle/Gears: 3.42 posi/ 3.90

Classifieds Rating: (0)
Re: is my drive shaft bad or my trans

That could be it too, I would check that also. A quick check would be to roll on under and see if the have any play in it, with the drive shaft still installed you shouldn't be able to feel any play in the u-joints. I've seen people drive around and not even notice a vibration from u-joints that have long lost their needle bearings. True story when me and my brother tore his 4x4 chevy apart i took the driveshaft out and the endcaps were broken in half and he said, " so that must have been the drive vibration i felt". LOL. The vibration you explain seem like something worse though like a bend driveshaft or a realy off balanced tire.
__________________
"Speed has never killed anyone, suddenly becoming stationary... that’s what gets you.”-Jeremy Clarkson ,TopGear
Iroc-Z28Man is offline vBGarage Page   Reply With Quote
Old 11-06-2009, 03:01 AM   #7
Junior Member
 
bjm1206's Avatar
 
Join Date: Aug 2009
Posts: 88

Classifieds Rating: (0)
Re: is my drive shaft bad or my trans

The brand new wheels and tires were on the car when i bought it i noticed the vibration when i test drove it, the PO said that his mechanic said that it was the u-joints, so i replaced them, thats when i noticed the hose clamps on the drive shaft, not sure what they were on there for. So I took them off, and it did not make a difference. It shakes so bad that the cd player skips and everything in the whole car rattles.
bjm1206 is offline vBGarage Page   Reply With Quote
Old 11-06-2009, 03:41 AM   #8
Senior Member
 
Shadygrady's Avatar
 
Join Date: Jan 2006
Location: Flowood,MS
Posts: 1,470
Car: 87 IROC Z
Engine: 5.7 L98 TPI
Transmission: 700r4,2500 stall
Axle/Gears: G80,10 bolt 3.42's

Classifieds Rating: (3)
Re: is my drive shaft bad or my trans

When I first got my car It did this.I got new tires,new rims,had the front end checked and started rebuilding it.Of course the last thing I did is what made it go away.Ball joints were my problem but it could be anything anyone has listed.My vibration was about 70 mph.I also recently had some older tires on my car and got a vibration.Bought a new set of tires and alignment and was like a new car.
Shadygrady is offline vBGarage Page   Reply With Quote
Old 11-06-2009, 03:59 AM   #9
Senior Member
 
MADMAXGTA's Avatar
 
Join Date: Mar 2007
Location: Buckeye A.Z.
Posts: 470
Car: 89 GTA hardtop
Engine: Stealth rammed vortec 350
Transmission: bowtie stage 2 700r4
Axle/Gears: 3.27 9 bolt

Classifieds Rating: (1)
Re: is my drive shaft bad or my trans

check for wheel weights on the tires.
MADMAXGTA is offline vBGarage Page   Reply With Quote
Old 11-06-2009, 11:33 AM   #10
SSC
Senior Member
 
SSC's Avatar
 
Join Date: Jul 2001
Location: Pueblo Co
Posts: 3,970
Car: No more birdy

Classifieds Rating: (0)
Re: is my drive shaft bad or my trans

Well I dont think its the u joints. These cars are prone to driveshaft issues. Take the ds out send it to a driveline shop for ballance. Mine was so far out of whack it wasent funny. Actually had 2 dirve shafts ballanced for my bird for the different transmissions ive had in it.
__________________
1976 SWB C10 3/4 drop, gen VI 454/M3.
1973 Buick Apollo wifes play car. Chevy 383/S3.
SSC is offline vBGarage Page   Reply With Quote
Old 11-06-2009, 02:01 PM   #11
Junior Member
 
bjm1206's Avatar
 
Join Date: Aug 2009
Posts: 88

Classifieds Rating: (0)
Re: is my drive shaft bad or my trans

Thanks i will do that over the winter
bjm1206 is offline vBGarage Page   Reply With Quote
Old 11-06-2009, 02:43 PM   #12
Senior Member
 
Burnout91's Avatar
 
Join Date: Jul 2006
Location: Palmdale, CA.
Posts: 724
Car: '91 Z28 L98 G92
Engine: Modded L98
Transmission: Modded 700R4
Axle/Gears: Modded 10-Bolt

Classifieds Rating: (0)
Re: is my drive shaft bad or my trans

Check into balancing the drive shaft & pinion yoke together. Worked great on my car.

Bill
__________________
1991 Camaro Z28 - L98 G92 G80 N10 B2L J41- Stock short-block, HSR w/BO91 EGR Mod,
Modded Air Lid, BBK 58mm TB, AFR 195 Eliminator Heads, Comp 280XFI cam, Crane Gold 1.6:1 roller rockers, AFR Hydra-Rev Kit, 30# injectors, Kirban AFPR, EP381 fuel pump, Dyno Don's headers & exhaust, Kevin91Z Tune, Yank SS4000 stall, Pro Built S/S 700R4, JG1 Driveshaft, 3.73:1 Axle, TA girdle / diff cover, (Real) Front Brakes, Hurst Dual Gate shifter, Dyno Don's SFC's, LCARB's, Boxed LCA's, KYB struts & shocks...
**Original & FINAL Owner**
Burnout91 is offline vBGarage Page   Reply With Quote
Old 11-06-2009, 02:43 PM
ThirdGen
1992 Camaro




Paid Advertisement


Reply

Go Back   Third Generation F-Body Message Boards > Tech Boards > Transmissions and Drivetrain

Tags
1986, 1995, bad, balancing, bend, camaro, differential, drive, driveshaft, effects, end, ore, rear, shaft, vibration
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

 


1982 Camaro '82 || 1983 Camaro '83 || 1984 Camaro '84 || 1985 Camaro '85 || 1986 Camaro '86 || 1987 Camaro '87 || 1988 Camaro '88 || 1989 Camaro '89 || 1990 Camaro '90 || 1991 Camaro '91 || 1992 Camaro '92


All times are GMT -5. The time now is 09:34 PM.


Powered by vBulletin® Version 3.7.5
Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.5.2
All content copyright © 1997 - 2012 ThirdGen.org. All rights reserved. No part of this website may be reproduced without the expressed, documented, and written consent of ThirdGen.org's Administrators.

Emails & Contact Details