Have you lowered your car?
Thread Starter
Member
Joined: Aug 2004
Posts: 180
Likes: 0
From: Fresno, CA
Car: 1992 Camaro RS
Engine: 305 V8
Have you lowered your car?
I just put some new wheels and tires on my car, and it needs to be lowered to look proper. I'm trying to decide between a 1" drop front and rear, or a 1.3" drop in the back and a 1.6" drop in the front. these are the springs I'm going to use SPRINGS on SALE.
I think the 1.3/1.6 combo will be better, but I just don't want my car to sit at a big angle and look like a dragster. I don't think it will because 3/10 of an inch isn't that much, but I'd like some other people's opinions.
Here's some pics of the car.
I think the 1.3/1.6 combo will be better, but I just don't want my car to sit at a big angle and look like a dragster. I don't think it will because 3/10 of an inch isn't that much, but I'd like some other people's opinions.
Here's some pics of the car.
Senior Member
Joined: Jul 2000
Posts: 992
Likes: 0
From: Tx
Car: 92 Z, 91 Formula, 04 CTS, 01 Tahoe
Engine: 355 forged 4 bolt, SuperRam, 58mm t
Transmission: T5, looking for t-56
I really don't think it's going to rake the car much. Personally,I would go with the 1.3/1.6 springs. I just think in my opinion that these cars look better without all that wheel well gap.
Supreme Member
iTrader: (1)
Joined: Feb 2004
Posts: 1,963
Likes: 0
From: Long Neck, De
Car: 2002 SS
Engine: Ls1
Transmission: T56
Axle/Gears: 3:42 posi
hey what size are those z06's mine are 18"s 10.5's in the rear 9.5 in the front.. i just wanted to lower my car so there was no fender to tire gap if possible... so i'll like to see how yours turns out.. mine arent even mounted yet
Member
Joined: Sep 2004
Posts: 212
Likes: 0
From: moore, ok
Car: 86 IROC-Z (daily driver) 87 IROC-Z (under construction)
Engine: 305 H.O.
Transmission: T-56
Go with the 1.3/1.6 drop. you'll be happy with it. just my
I lowered my car about 2 mths ago after i put my 18" on, and everybody i know loves it!
I lowered my car about 2 mths ago after i put my 18" on, and everybody i know loves it!
Trending Topics
Joined: Sep 2003
Posts: 25,895
Likes: 429
From: Pittsburgh PA
Car: 89 Iroc-z
Engine: 555 BBC Turbo
Transmission: TH400
Axle/Gears: MWC 9” 3.00
Heres my prokit. Its like 1 inch drop all around, or suppose to be like that. I got alittle rake and want alittle lower.
Joined: Sep 2003
Posts: 25,895
Likes: 429
From: Pittsburgh PA
Car: 89 Iroc-z
Engine: 555 BBC Turbo
Transmission: TH400
Axle/Gears: MWC 9” 3.00
Those sportlines dont look too much different than the ProKit. Maybe .5 inch difference in front but like 1inch in rear. Doesnt look all that low.
Last edited by Orr89RocZ; Sep 29, 2004 at 05:18 PM.
can't say i have.....i've thought about lowering it though. roads are bad around here.

http://s89724942.onlinehome.us/image...e/P6280042.JPG

http://s89724942.onlinehome.us/image...e/P6280042.JPG
Supreme Member
Joined: May 2002
Posts: 1,951
Likes: 1
From: pefferlaw ontario
Car: 1987 iroc-z custom
Engine: 355 tuned port
Transmission: 5spd baby, only way to go
Axle/Gears: 3.45
Originally posted by 1BadThirdgen
Found this picture on cardomain.com, these wheels are tucking for sure.....Don't know specs though.....
Found this picture on cardomain.com, these wheels are tucking for sure.....Don't know specs though.....
thats 84camaros car...he has airbags...cant wait until i get mine bagged...
i only have mine dropped 4 inches..
iroc2nv
Senior Member
iTrader: (1)
Joined: Oct 2003
Posts: 935
Likes: 0
From: Southern Maryland
Car: 91 Z28
Engine: L98
Transmission: built 700R4
Axle/Gears: 3.42
Originally posted by iroc2nv
thats 84camaros car...he has airbags...cant wait until i get mine bagged...
i only have mine dropped 4 inches..
iroc2nv
thats 84camaros car...he has airbags...cant wait until i get mine bagged...
i only have mine dropped 4 inches..
iroc2nv
Supreme Member
Joined: Oct 2002
Posts: 2,378
Likes: 0
From: Thornton colorado
Car: 91 Camaro RS
Engine: TBI
Transmission: 700r4
Originally posted by camaro05
My sportlines [IMG][/IMG]
My sportlines [IMG][/IMG]
omg camaro05 i origianlly was going to wait on lowering mine in fear of tearing the front end up a tad but damn i think you just made me order a set of those that is one bad looking ride. That is liek the stance, whats your wheel tire combo that looks nice.
Chomp, kinda looks liek my car before the huge hood monster came for me, looks sweet get soem dark tint.
Senior Member
iTrader: (2)
Joined: Oct 1999
Posts: 893
Likes: 0
From: Hattiesburg, MS, USA
Car: 1992 Jade Green---Trans Am Converti
Engine: LS1
Transmission: T56
Short Eibach's with Ground-Control adjusters. Not sure how far down it went, but I can go lower or higher (Although not a cool as airbags can...)
Supreme Member
Joined: Oct 2002
Posts: 2,378
Likes: 0
From: Thornton colorado
Car: 91 Camaro RS
Engine: TBI
Transmission: 700r4
yea imo body colored door handles just look cheap, like you were to lazy to take them off and spray them seperate, i would however get rid of that trim down the center of your door and show off that body.,
Nice job kandied i think ah hell i'll get the the same springs as camaro05 and just drive careful, then you bust out the airride pics and change my mind again. I want it sitting on bags:hail:
Nice job kandied i think ah hell i'll get the the same springs as camaro05 and just drive careful, then you bust out the airride pics and change my mind again. I want it sitting on bags:hail:
Senior Member

Joined: Jul 1999
Posts: 700
Likes: 0
From: Pineville, NC US
Car: An '87 Italian Retard Out Cruisin'
Engine: LS1 install in progress
Transmission: 4L60e
Axle/Gears: 9 bolt
Originally posted by Kandied91z
no..either they stay black or they disappear. haven't decided.
no..either they stay black or they disappear. haven't decided.
Joined: May 2002
Posts: 2,302
Likes: 13
From: Chicagoland
Car: 1983 Daytona Trans Am
Engine: LG4
Transmission: T5
Axle/Gears: 3.73
Originally posted by Kandied91z
lower is over rated...
lower is over rated...
Senior Member
iTrader: (1)
Joined: Oct 2003
Posts: 935
Likes: 0
From: Southern Maryland
Car: 91 Z28
Engine: L98
Transmission: built 700R4
Axle/Gears: 3.42
Originally posted by irocbirdbuilder
omg camaro05 i origianlly was going to wait on lowering mine in fear of tearing the front end up a tad but damn i think you just made me order a set of those that is one bad looking ride. That is liek the stance, whats your wheel tire combo that looks nice.
Chomp, kinda looks liek my car before the huge hood monster came for me, looks sweet get soem dark tint.
omg camaro05 i origianlly was going to wait on lowering mine in fear of tearing the front end up a tad but damn i think you just made me order a set of those that is one bad looking ride. That is liek the stance, whats your wheel tire combo that looks nice.
Chomp, kinda looks liek my car before the huge hood monster came for me, looks sweet get soem dark tint.
Junior Member
Joined: Sep 2004
Posts: 35
Likes: 0
From: St. Louis, MO
Car: 86 Camaro Z28
Engine: 305 Carbeurated
Transmission: 700-R4
I just put the 17x8 slp ss wheels on mine. I also put hotchkis 1 inch lowering springs. Now my car is a z28 so the ground effects aren't as low as the rs's. On my car i probablay could have done the 1.6 or 1.3 but the 1 inch looks great. Since you have an rs i'd just do the 1 inch springs.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
9192camaro
Engine/Drivetrain/Suspension Parts for Sale
16
Feb 3, 2019 12:21 AM
IROCZDAVE (88-L98)
Interior Parts for Sale
4
Oct 6, 2016 09:08 AM










