so my car has been running like **** and stalls when put into gear it feels like it was running on 4 cyl, so I disconnected the battery moved some grounds around wasn't sure if aluminium heads were grounding properly, once I connected the battery again I wouldn't get a crank so I start taking a closer look into wiring harness and notice a lot of one wires splitting into 2 and weird connects so I wanted to know if these are stock connections or someone did it,

 

Was there black tape on them about an inch wide as that would be factory. where are the wires going to? From the pics they look to be on the driver side

 

they were almost covered in blacktape, one goes to a connector on passenger side of tpi plenum there is a little box sensor, one goes to sensor at the front of the intake a temp sensor i think, the other one ill have to look at again.

 

The first two pictures look like factory crimps with the dried-out fabric tape.
The last picture, I cannot pinpoint the wires. What was the connector clipped on? The A/C compressor clutch by any chance?

Lou