Ok so I bought a VATS bypass module from bakerelectronix and it says that I need to find fuel enable pin on my So me and and my dad pulled ECM out and pulled out connectors on the back and we had 3 connectors colored light blue and one 2 of them one side was light blue the other side was gray and we looked and looked but couldn't find any connector that was labeled F at all much less find pin F10 I need help where is my f10 pin/connector and if I don't have one which one is the fuel enable pin? An where is it? Please help and thank you and my car has the 5.7 TPI

 

http://www.chevythunder.com/fuel%20i...%20pinouts.htm


http://austinthirdgen.org/mkportal/m...ine_wiring.gif

 

Thanks man but trust me none if the connectors that connect to my computor are F and we see not F10 pin

 

See where the pic shows F1? 10 spots to the right is F10.

If not then the second link is the wiring diagram and it shouldn't be very hard to find what you are looking for. Just trace the wires.

Would be much easier if you would just buy the book for the car...

 

We have the book for the car.... As well as 3 diagrams iv been suggested and they all say the same thing F10 well that's fine and dandy and I'd be glad to count over like u suggested but you see none of the connectors are labled F I have A's, B's, C's, and D's but nothing further

 

If you cant find the fuel enable wire with the wiring diagrams in front of you, then maybe you shouldn't be working on the car...

 

[QUOTE=willexoIX;5876171]If you cant find the fuel enable wire with the wiring diagrams in front of you, then maybe you shouldn't be working on the car...[/QUOTE
Ok.... If you so smart where is itt suppose to be describe to me how u would get to the F10 (fuel enable wire)

 

Clearly you don't have a pin F10. Therefore you need to follow the wiring diagram to find your fuel enable wire.

I'm not going to give you the answer you want, otherwise you will not learn how to read the wiring diagram.

Yes I am a smart guy, I'm an Electronics Engineer smartass.

 

Ok so if your not gonna help me then why are u commenting?

 

Watch out, we've got a badass over here.
We can't help you, if you won't help yourself.

Look up Austin Thirdgen. There are lots of helpful diagrams there.

 

Ok everyone chill the **** out ok no need for this to get violent ok look I'm more than happy to search somemore for the fuel enable wire but what I need u guys to do is tell me the general location I'm looking if the wiring schematics and I don't see anything pertaining to fuel enable wire so where is it? Is it part of the cluster that hooks to the ECM or...? Where a general location for me to search

 

I do see a C11 that is dark blue that runs to 4 of my 8 injectors is this it? The other 4 are hooked to C12 and it's dark green? Is this right?

 

http://www.austinthirdgen.org/mkport...m_pass-key.jpg


C207 post #1
https://www.thirdgen.org/forums/ltx-...formation.html

 

If you get tired of the headache, like I did, I would be willing to spend the extra $ 30.00 for a basic VATS removal and either send back what you have or sell it on EBay
Talk to this man. A much better choice and he can add a few nice extra performance enhancing features if you want.=
https://www.thirdgen.org/forums/elec...ing-tuned.html


I would at least get the extras I did.