1 3/4 headers
#2
TGO Supporter/Moderator
iTrader: (12)
Join Date: Jul 1999
Location: SALEM, NH
Posts: 11,720
Likes: 0
Received 89 Likes
on
75 Posts
Car: '88 Formula, '94 Corvette, '95 Bird
Engine: LC9, 355" LT1, LT1
Transmission: T5, Zf6, 4L60E
Axle/Gears: 3.42, Dana44 3.45, 3.23
Re: 1 3/4 headers
#3
Junior Member
Join Date: Jul 2012
Location: Colorado
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Iroc-z
Engine: 350
Transmission: 700R4
Axle/Gears: 2.77 9-Bolt
Re: 1 3/4 headers
I have a pair of Hooker Super Comp Shorty headers same as these http://www.hawksmotorsports.com/hook...rs-non-coated/
I can let them go $75 and also have the exhaust that goes with them however would have to work something out for shipping these are also setup with emissions.
I can let them go $75 and also have the exhaust that goes with them however would have to work something out for shipping these are also setup with emissions.
Last edited by xbleedblackx; 09-06-2018 at 12:26 PM.
#4
Supreme Member
iTrader: (7)
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,674
Likes: 0
Received 106 Likes
on
65 Posts
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
Re: 1 3/4 headers
I have a pair of Hooker Super Comp Shorty headers same as these -
I can let them go $75 and also have the exhaust that goes with them however would have to work something out for shipping these are also setup with emissions.
I can let them go $75 and also have the exhaust that goes with them however would have to work something out for shipping these are also setup with emissions.
#5
Junior Member
Join Date: Jul 2012
Location: Colorado
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Iroc-z
Engine: 350
Transmission: 700R4
Axle/Gears: 2.77 9-Bolt
#7
Junior Member
Join Date: Jul 2012
Location: Colorado
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Iroc-z
Engine: 350
Transmission: 700R4
Axle/Gears: 2.77 9-Bolt
Trending Topics
#8
Junior Member
iTrader: (1)
Join Date: Feb 2009
Location: Dallas, TX
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Trans-am GTA
Engine: 400 Small block
Transmission: T-5
Axle/Gears: 3.42-3.73
Re: 1 3/4 headers
I will have a set of Dyno Don's in a few months they were built to my spec 2 1/2 inch collector with 2 1/2 inch Y pipe. I am going to full length this winter. May be to long for you to wait but thought I would through this out.
Mark Madarash
Mark Madarash
Thread
Thread Starter
Forum
Replies
Last Post