I was wondering what the proper way to install the a-pillars in a 92 Camaro are? My passenger side a-pillar is screwed in, while the driver side is just hanging. It's annoying as hell, and I would like to know how to fix it. Thanks.

 

There's supposed to be two clips along the windshield edge that press into 2 mounting points there. The thing is though, they allways break off when the pillar covers are removed, and I am not sure if new clips are available.

 

 

For pics/info, start with post #52 of the following link:

https://www.thirdgen.org/forums/body...rvation-3.html

JamesC

 

Thanks for the info, I'll see what I can do...

 

You can use the same push in fastners that are used on the door panels bwith no problems.

 

I think Autozone might carry generic replacements. Look where they sell all their plastic GM replacement screws. I need some too but keep forgetting to check when I am there. Worst case, junkyard.

 

The upper and lower fasteners aren't the same. The two can be seen in the link I provide above.

JamesC