Help - Steering Column Repair Kit Install
Thread Starter
Supreme Member
iTrader: (5)
Joined: Aug 2006
Posts: 2,491
Likes: 6
From: Cleveland, Ohio
Car: 89' IROC-Z
Engine: LO3
Transmission: 700R4
Axle/Gears: 10-Bolt/2.73
Help - Steering Column Repair Kit Install
I bought this kit after my car was broken into (before I bought it).
I'll update as I mess with it. Thanks guys.
Photo 1 is the Key Warning Buzzer Contact.
I'm using these videos as a guide.
NOTE: In video 3 @0:16 (Attached Photo 2). The slide gear that comes out (also in the repair kit). I just found out I need the rod that this grabs, to start the car. This rod actually goes deeper into the column.
I believe this is something like what I need.
Lastly, I need to remove the turn signal lever and mechanism around the column to install new housing.I believe this is something like what I need.
I'll update as I mess with it. Thanks guys.
Photo 1 is the Key Warning Buzzer Contact.
Last edited by I H8 WWD; Aug 18, 2013 at 08:19 PM.
Thread Starter
Supreme Member
iTrader: (5)
Joined: Aug 2006
Posts: 2,491
Likes: 6
From: Cleveland, Ohio
Car: 89' IROC-Z
Engine: LO3
Transmission: 700R4
Axle/Gears: 10-Bolt/2.73
Re: Help - Steering Column Repair Kit Install
Need help finding an ignition switch actuator rod. I'd like not to have to go to a pull a part if possible. So I can work and just wait for the part to my door. Help me out guys, thanks.
Thread
Thread Starter
Forum
Replies
Last Post
evilstuie
Exhaust
24
Feb 28, 2016 03:33 PM
