Hey was just wonder who bores out our tbi units. I got some TPI blades i would like to get put in there let me know

 

Try here:

http://www.crossfire.homeip.net:81/c...hrottle+Bodies

and the point-of-contact would be:

dlplett@swko.net

a.k.a. Lionsden
Dan Plett
Liberal KS

I don't know if he has bored the dual-bore TBI units before, but he has the tools to do the single bore units, and the ID on those is the same as on the 4.3/5.0/5.7 liter TBI units (1 and 11/16 inside diameter). Write and ask him, then post back here to update this thread. HTH.

 

aight heres the deal he will do stock tbs to 2" bores for 137. Good deal to me, im sending it out tomoro. will post pics when i get it back

 

for 137 he bores it out and but the 2 in plates or u supply him with the plates

 

Yes sir... Just need to send him the bare base. I got one from ebay so I can still drive around while this is happening so for a total of 150$ i got a brand new 2" bore tbi unit...


SWEEEEEEEEEEEEEEEETTTTTTTTTTTTT

 

but do u give him the plates or he has them?

 

At this time the only throttle bodies I bore are for the Crossfire.


Crossfire Throttle Bodies

 

now he tells me Back to the drawingboards

 

If that's what you're looking for you might want to check this out:

Bored TBI Units