Since DCS closed down,is there anyone left who can bore and bush the Crossfire 1-bbl throttle bodies?

I think a carburetor rebuild/restorer can do this. I remember seeing it advertised somewhere.

This guy does it. But I never heard of him.
http://www.musclecarsoftexas.com/cro...ction-1982-84/
A crossfire TBI done right will still have the balance ports on it, so that would be a good question for him if you decide to give him a call.

balance ports - yes, that is what I was worried about. DCS did them right. Thanks for the info!

gheatly- Did you ever get yours done?

FWIW- Maxbore did mine. Balance ports were left in place too. Jorge does an awesome job. He got mine out to 1.92" and did the bushings too.

http://maxbore.com/

Try - he does a very good job with TB's

http://www.rvmorsemachine.com/product.htm


//RF

I still have a set sleeved to about 50mm

I know this is an old thread.. kauboy you say u have a pair that are 50mm im curious do you know how much cfm you get out of them? thx

Not sure on CFM, but the guy I bought them from was going to put them on a built 383 sbc.

Still for sale

Do you have some pics? How much are looking to get for them?

im interested

are there any current boring solutions