Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

car loses spark after it worms up???

Old Sep 1, 2002 | 06:03 PM
  #1  
Night Hawk 92's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2002
Posts: 19
Likes: 0
car loses spark after it worms up???

I'm running out of ideas!!!

I changed the coil, ignition modual,and pick up coil.

I checked for power to the coil...its there.
I directly grounded the the coil to the batt.

Still after running for about 1min the car shuts off and wount run for about 4 hours!!!!

WHAT SHOULD I DO NEXT!!!
Reply
Old Sep 1, 2002 | 07:17 PM
  #2  
ede's Avatar
ede
TGO Supporter
 
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
check the modual, doesn't really matter if you just replaced it, check it again when the problem develops.
Reply
Old Sep 2, 2002 | 04:49 PM
  #3  
Night Hawk 92's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2002
Posts: 19
Likes: 0
I will try that....the old one I pulled out tested ok cold and hot I just replaced it to eliminate any possibilities.
Reply
Old Sep 2, 2002 | 05:49 PM
  #4  
RB83L69's Avatar
Supreme Member
 
Joined: Jul 1999
Posts: 18,457
Likes: 16
From: Loveland, OH, US
Car: 4
Engine: 6
Transmission: 5
Will it start if you squirt starting fluid into it? (Might not be an ignition problem at all...)
Reply
Old Sep 3, 2002 | 12:50 PM
  #5  
Night Hawk 92's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2002
Posts: 19
Likes: 0
The car does get fuel...I have a in line spark tester that will allow the car to run well checking for spark, after about a minute the spark just stops.

I tried grounding the distributor and the coil directly to the batt. along with the intake manifold just in case......still loses spark!!!
Reply
Old Sep 3, 2002 | 01:01 PM
  #6  
ede's Avatar
ede
TGO Supporter
 
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
use a hair dryer or heat gun to warm it up, see if you can make it fail
Reply
Old Sep 3, 2002 | 06:00 PM
  #7  
Night Hawk 92's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2002
Posts: 19
Likes: 0
I will pull out the heat gun and give it a try....I will try anything at this point!
Reply
Old Sep 3, 2002 | 08:33 PM
  #8  
BOTTLEDZ28's Avatar
Supreme Member
iTrader: (9)
 
Joined: Sep 1999
Posts: 3,871
Likes: 24
From: Mass
Engine: 350 TPI
Transmission: A4
Axle/Gears: 3.23
this may be a long shot here but maybe heat is causing resistance is an ignition wire somwhere. have you done any modifitying to anything electrical at all on your car? does the car just shut off like turning the key off?
Reply
Old Sep 4, 2002 | 12:22 PM
  #9  
Night Hawk 92's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2002
Posts: 19
Likes: 0
Yes...the car just shut off like someone turned the key.

I had a crane cams booster box and coil, I went back to stock after all this started.

Well...you where write ede, I took the module off the car and checked it after the car wouldn't run. It was bad! I went out and picked up a new one (A/C Delco this time) and the car runs great. I guess that is what I get for buying a no name part the first time around.
Reply
Old Sep 4, 2002 | 12:24 PM
  #10  
Night Hawk 92's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2002
Posts: 19
Likes: 0
I almost forgot.....

THANKS FOR ALL THE HELP
Reply
Old Sep 4, 2002 | 12:35 PM
  #11  
TomP's Avatar
Supreme Member
 
Joined: Mar 2000
Posts: 13,414
Likes: 6
From: Central NJ, USA
Car: 1986 Firebird
Engine: 2.8 V6
Transmission: 700R4
NightHawk, when you replaced the module the first time, did you use the heat sink grease with it? If you don't use the grease, you'll overheat the module in no time. And, did you use the grease with the new module? If it didn't come with the stuff, you can buy a little tube of "heat sink grease" from Radio Shack for $5.
Reply
Old Sep 4, 2002 | 06:06 PM
  #12  
Night Hawk 92's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2002
Posts: 19
Likes: 0
Yea...I put it on both times. I have a large tube of it from carquest.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
midge54
LTX and LSX
21
Dec 27, 2019 04:14 PM
Azrael91966669
DIY PROM
25
Jun 20, 2017 04:04 AM
jharrison5
Engine Swap
5
Aug 19, 2015 05:53 PM
Armored91Camaro
DIY PROM
3
Aug 12, 2015 09:41 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 12:15 AM.