Im going to be swaping a l98 with a non cc carb on it into a cc carb z28 car that has a mechnicle pump my iroc has a electric intank pump regulated down to 6 psi for the carb how would i install a inline pump in my z28 thats equipt with a mechnicle pump? I would ike to keep the stock fuel tank.

 

What year is the Z28 this is going into?

 

84 lg4

 

Are you just looking to have an electric pusher, or replace the mechanical?

Most people mount the in-line electric back where the line goes over and in front of the axle.

 

well im pulling the 305 with the mechnicle put and installing the l98 which has no fuel pump lobe on the roller cam so that means there will be no fuel pump on the z28 to fuel the 350 the iroc has ai ntake pump and i put the mallory 4309 regulaor on it to keep it at 6psi i would like to use a holley red pump to fuel the 350

 

That's it, then. Put it back by the axle.

 

is there only one fuel line running to a 84 lg4 fuel tank how will i have to modify the lines so that the pump gets fuel from the tank?

 

get an aeromotive or holley performance pump.the red pump and the blue pumps burn out after a year or so mebbe 2 i have gine thru 4 pumps in the past 5 yrs, now i just ordered a new pump. just givin my .02

 

I'm doing the same thing with my 84 T/A...though my block has the mount for the mechanical pump, it's not drilled for the pump shaft so I have to install an electric pump. Do you have the summit part number of the one you just ordered? Or the Holley Performance pump you just mentioned? The Aeromotive ones are damn expensive.