i have a 88 rs with a 350 with 9:1 compression and i was wondering what would be a good heads and cam set up i am looking for around 400 420 flywheel horse and 400 in torque any ideas

 

trickflow makes some nice heads and matching cams. That is what i run on my stock bore 350(195cc intake runner TFS heads, 494 lift TFS cam). I bought my heads & cam together in a kit from summit racing-TFS-K314-420-395. They work. Kit is supposed to make about 420 hp.

 

yea i was looking at that actully but do you what stall i would have to use if any i have a th350 tranny

 

About 3000. 3500 wouldn't be excessive if you race it regularly.

 

i want the car to be somewhat streetable do think i will have trouble driving on the street

 

No. Higher stall takes a little getting used to. About 5 minutes of driving, typically.

 

thanks for the advice guys i think that i am going to go with the set up that dp Z28 said TFS-K314-420-395 and a 3000 stall

 

I really like my Canfield heads... They only cost like $1050 with good springs and perform quite well right out of the box.

 

I run a TCI streetfighter 3000 stall. It is a good converter, but a little too much stall for a daily driver,I.M.O. If I did it over again I would go w/ like a 2600. It all depends on what you plan on doing w/ it.

 

yea i was thinking about going with a 3000 stall but i am going to have to drive it into the city 3days a week and sit in traffic but i think i will be able to manage i have driven worse things lol