please help on ignition wireing my car is disabled!!!
please help on ignition wireing my car is disabled!!!
Ahhh I finally did it I ripped out the hacked in MSD ignition box that the PO spliced into the ignition coil and distributor. However the problem is now I don't know what wire goes where. The big fat Pink wire I know goes to the wire loom I was able to match that one up. I do not know where the other 3 go. Coming off the coil There is a skinny pink wire next to a white wire, then there is a white wire with some sort of connector on the end of it next to the fat pink wire. The wires coming off the distributor are both white so I'm not sure where they go, somebody please help my 1990 IROC is now disabled and I wanna drive it.
Moderator
iTrader: (1)
Joined: Mar 2002
Posts: 18,432
Likes: 233
From: Chasing Electrons
Car: check
Engine: check
Transmission: check
Re: please help on ignition wireing my car is disabled!!!
On the diagram the wire marked TO IGN is the heavy pink, it is paired with the one that goes to the tach (white).
The pair that go between the coil and the module are pink & white. White going to the C terminal and pink going to the + terminal.
Note that within the coil the Tach lead and the C (on ICM) are tied together. Same for the pink wires, heavy pink is power to coil, which feeds through and provides power to ICM.
RBob.
The pair that go between the coil and the module are pink & white. White going to the C terminal and pink going to the + terminal.
Note that within the coil the Tach lead and the C (on ICM) are tied together. Same for the pink wires, heavy pink is power to coil, which feeds through and provides power to ICM.
RBob.
Re: please help on ignition wireing my car is disabled!!!
Thank you very much I hope this takes care of my problem I need to order a new connector now cause the stock wire is now ripped away from the connector ahhh it is all screwed up, why do people do this to camaros... I mean have some respect
Supreme Member

Joined: Jul 2009
Posts: 2,328
Likes: 9
From: Kitchener, ON
Car: 1988 GTA
Engine: LB9
Transmission: T5
Axle/Gears: 3.45
Re: please help on ignition wireing my car is disabled!!!
Standard Motor Products makes the connectors. You just have to join them together. Try these part #'s:
S551
S562
S563
TX3A
on the "part number" section of this website:
http://eaccess.smpcorp.com/eCatalogs...?vehicle=22417
Any auto parts store on earth can either order a Standard part, or at least cross it and get what you need.
S551
S562
S563
TX3A
on the "part number" section of this website:
http://eaccess.smpcorp.com/eCatalogs...?vehicle=22417
Any auto parts store on earth can either order a Standard part, or at least cross it and get what you need.
Moderator
iTrader: (1)
Joined: Mar 2002
Posts: 18,432
Likes: 233
From: Chasing Electrons
Car: check
Engine: check
Transmission: check
Re: please help on ignition wireing my car is disabled!!!
RBOb.
Trending Topics
Re: please help on ignition wireing my car is disabled!!!
hey thanks i will hit a couple up this weekend
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
9192camaro
Engine/Drivetrain/Suspension Parts for Sale
16
Feb 3, 2019 12:21 AM




