Oil Pressure
Thread Starter
Member
Joined: Sep 2011
Posts: 152
Likes: 0
From: Florida
Car: 1991 Pontiac Firebird Trans Am
Engine: 1987 Chevy 355 TPI Mild Cam
Transmission: 5-Speed T-5 WC
Axle/Gears: 3.42
Oil Pressure
My cars oil pressure is going crazy, it hardly goes over 30psi and that is only when the engine is on while driving constantly. (freeway) But when I stop and idle, the psi goes to 0 or very close to. Not sure what is causing this, any ideas?
I would assume oil pump but thats just me guessing.
Also, my fuel pump make a really bad whining noise and before I even touch E my car dies from lack of gas. (not sure if the gauge is off) Sometimes the engine will run real rough and just die like its not getting enough fuel. Not sure whats up, if the fuel pump is going or what...
I would assume oil pump but thats just me guessing.
Also, my fuel pump make a really bad whining noise and before I even touch E my car dies from lack of gas. (not sure if the gauge is off) Sometimes the engine will run real rough and just die like its not getting enough fuel. Not sure whats up, if the fuel pump is going or what...
Joined: Oct 2001
Posts: 12,211
Likes: 1,135
From: Il
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: Oil Pressure
could be a bad sending unit or bad bearings in the motor..
Senior Member
iTrader: (3)
Joined: Aug 2008
Posts: 614
Likes: 0
From: Memphis, TN
Car: 1992 z28 Purple Haze
Engine: 5.7L Tuned Port Injection
Transmission: 700R4
Axle/Gears: 3.23 both spinning
Re: Oil Pressure
An easy check for the oil pressure is to install an aftermarket gauge. I'd be willing to bet your factory gauge or sending unit is not operating correctly.
Thread Starter
Member
Joined: Sep 2011
Posts: 152
Likes: 0
From: Florida
Car: 1991 Pontiac Firebird Trans Am
Engine: 1987 Chevy 355 TPI Mild Cam
Transmission: 5-Speed T-5 WC
Axle/Gears: 3.42
Re: Oil Pressure
I assume you are talking about the first part of the post (oil pressure)
Where is the sending unit located? And what exactly is it? I assume it is what takes the data from the engine and tells the gauge what to display but I just want to make sure.
Thanks for the reply's.
Where is the sending unit located? And what exactly is it? I assume it is what takes the data from the engine and tells the gauge what to display but I just want to make sure.
Thanks for the reply's.
Last edited by Termanalor117; Mar 26, 2012 at 02:28 PM. Reason: Add info
Joined: Oct 2001
Posts: 12,211
Likes: 1,135
From: Il
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: Oil Pressure
its on the driver side rear of the motor above the oil filter.
The oil pump pickup could have fallen off of the pump also..
The oil pump pickup could have fallen off of the pump also..
Thread Starter
Member
Joined: Sep 2011
Posts: 152
Likes: 0
From: Florida
Car: 1991 Pontiac Firebird Trans Am
Engine: 1987 Chevy 355 TPI Mild Cam
Transmission: 5-Speed T-5 WC
Axle/Gears: 3.42
Re: Oil Pressure
Is this the sender you are talking about?
http://www.partsgeek.com/catalog/199...re_sender.html
And why is one cheaper than the other, I don't see a difference...?
http://www.partsgeek.com/catalog/199...re_sender.html
And why is one cheaper than the other, I don't see a difference...?
Trending Topics
Thread Starter
Member
Joined: Sep 2011
Posts: 152
Likes: 0
From: Florida
Car: 1991 Pontiac Firebird Trans Am
Engine: 1987 Chevy 355 TPI Mild Cam
Transmission: 5-Speed T-5 WC
Axle/Gears: 3.42
Re: Oil Pressure
So the oil pressure will fluctuate up and down while idling and than go to 0, still a problem with the sender.
Joined: Nov 2010
Posts: 5,891
Likes: 84
From: Mantua NJ
Car: 1 Owner 1986 TA with a WS6 package
Engine: 5.0 EFI
Transmission: THM700R4
Axle/Gears: 277 Posi Speedo
Re: Oil Pressure
My car turns over but doesnt fire. It has spark and on members recommendations I have changed out the following: new fuel pump ( again), sending unit, ECM, coil, new battery, oil pressure sensor) I shot cold start into it and it tries to turn over but doesnt. Checked fuses, relays, couldnt find anything wrong. My cars sat in my garage over the winter and I started it up monthly then all of a sudden it just quit. Cranks over and doesnt fire.
I dont mean to hijack this thread but have tried almost everything I can think of.
Thread Starter
Member
Joined: Sep 2011
Posts: 152
Likes: 0
From: Florida
Car: 1991 Pontiac Firebird Trans Am
Engine: 1987 Chevy 355 TPI Mild Cam
Transmission: 5-Speed T-5 WC
Axle/Gears: 3.42
Re: Oil Pressure
Car dosen't knock, runs fine. Kinda rough sometimes but i think that was my half fast job at rebuilding the tranny. The exhaust is smooth sounding and no hickups or anything so I'm pretty sure the motor is good just the oil pressure thing.
Thread Starter
Member
Joined: Sep 2011
Posts: 152
Likes: 0
From: Florida
Car: 1991 Pontiac Firebird Trans Am
Engine: 1987 Chevy 355 TPI Mild Cam
Transmission: 5-Speed T-5 WC
Axle/Gears: 3.42
Re: Oil Pressure
It was the oil pressure sending unit, it had oil inside of it somehow. Thanks
Thread
Thread Starter
Forum
Replies
Last Post










