what is the exact length of a th200 driveshaft from an early 80's camaro? i need one for a th-350 swap. thanks

 

Here, check this link out. I hope it helps.

http://www.prestage.com/Tech+Info/Transmission/324.aspx

 

anyone have any hard numbers?

 

Not on hand but mine is laying in a corner collecting dust at the shop. I can measure it tommorow if no one else chimes in between now and then.

 

thanks

 

No problem. It's 51in from the end of the yoke to the end of the yoke. This should be a good measurement for a competent driveline shop but if not the shaft is 46 3/4, center of U-joint cap to center cap is 49 1/2 (this is the measurment most shops use)and the complete driveshaft ready to install should be 56 1/2in.

 

Just remember thats a 200c/TH350 short tail shaft measurment.

 

awesome man!!! i really appreciate it!!! btw, is yours for sale?

 

Not at this time, I had 2 of them sold one after the camaro was wrecked. I'm still debating if I'm going to drag this car again, I did have a TH350 in it at one time, if I decide to race it I'm going back to the TH350. I do recomend the hurst kit though, It comes with more goodies for the conversion.

 

i was looking at the b&m kit, what are the differences?