Torque converter, home made electronic push button
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Mar 2017
Location: Lorraine, Québec
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 Chevrolet CAMARO IROC-Z
Engine: 5.7 crate engine 300hp
Transmission: TH700R4
Axle/Gears: 3.73
Torque converter, home made electronic push button
I was a bit tired off my transmission going into lockup when I was driving around in the city.
So, I built myself an electronic bord to control the torque converter on my 700R4 with the push button of my B&M shifter. It basically make the push button act as a toggle switch. The board disable the selenoid of the torque converter as the car start. The led shows that it is off. When i'm on the highway, a simple push on the B&M button and it's enable than engage the torque converter . When I turn the car off , it goes back to disable.
Circuit board from robotshop.com
https://www.robotshop.com/ca/en/mini...switch-lv.html
I have tested it for the last month and I really appreciate it.
here is some picture.
Plastic case, circuit board, led and relay
Shifter and led
So, I built myself an electronic bord to control the torque converter on my 700R4 with the push button of my B&M shifter. It basically make the push button act as a toggle switch. The board disable the selenoid of the torque converter as the car start. The led shows that it is off. When i'm on the highway, a simple push on the B&M button and it's enable than engage the torque converter . When I turn the car off , it goes back to disable.
Circuit board from robotshop.com
https://www.robotshop.com/ca/en/mini...switch-lv.html
I have tested it for the last month and I really appreciate it.
here is some picture.
Plastic case, circuit board, led and relay
Shifter and led
Last edited by Sdallaire; 05-15-2018 at 08:41 PM.
Thread
Thread Starter
Forum
Replies
Last Post
indirocz28
NW Indiana and South Chicago Suburb
8
02-09-2006 04:32 PM