[NC] 3" true dual exhaust setup
#1
3" true dual exhaust setup
$100
It has an H-pipe in it, 2 flowmaster mufflers that turn down right in front of the rear axle, two fake cats(100% hollow) and is a direct bolt on if you have Hooker LT headers(3-bolt flange)
You will have to fab a bracket on each side (all we have are rubber exhaust hangers that the rods on the exhaust goes through. It works great).
This exhaust is nice in that it can be on and off in 5 minutes flat and sounds great.
I am upgrading to a mandrel bent 4" single.
Here is a picture and a couple videos!
It has an H-pipe in it, 2 flowmaster mufflers that turn down right in front of the rear axle, two fake cats(100% hollow) and is a direct bolt on if you have Hooker LT headers(3-bolt flange)
You will have to fab a bracket on each side (all we have are rubber exhaust hangers that the rods on the exhaust goes through. It works great).
This exhaust is nice in that it can be on and off in 5 minutes flat and sounds great.
I am upgrading to a mandrel bent 4" single.
Here is a picture and a couple videos!
Last edited by NufNuffZ28; 10-31-2014 at 02:38 PM.
Trending Topics
#16
Member
Join Date: Jun 2013
Location: Wahxaw, NC
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Pontiac Firebird Trans Am
Engine: 5.0 305 V8 FI
Transmission: 700R4 Automatic
Re: 3" true dual exhaust setup
How much ground clearance did you loose while using this setup?
Thread
Thread Starter
Forum
Replies
Last Post
downsouthboy
Tech / General Engine
4
08-29-2015 11:29 AM