Fuse next to battery keeps blowing.
#1
Member
Thread Starter
Join Date: Jun 2014
Location: Ny queens
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 GTA Trans Am
Engine: 5.7 350 TPI
Transmission: TCI transmission
Axle/Gears: 4th gen rear end. With 3.83
Fuse next to battery keeps blowing.
87 gta trans am
Tpi 350
There's a fuse next to the battery I think it's for the fuel pump?
When the engine get warmed up and I drive it the car will shut off and all the gauges will stop working like the power is cut off on the entire car. I look at the fuse and it blown. Does anyone know what this fuse does? Anyone have a schematic for that wire so I can trace it.
Tpi 350
There's a fuse next to the battery I think it's for the fuel pump?
When the engine get warmed up and I drive it the car will shut off and all the gauges will stop working like the power is cut off on the entire car. I look at the fuse and it blown. Does anyone know what this fuse does? Anyone have a schematic for that wire so I can trace it.
#2
Member
Thread Starter
Join Date: Jun 2014
Location: Ny queens
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 GTA Trans Am
Engine: 5.7 350 TPI
Transmission: TCI transmission
Axle/Gears: 4th gen rear end. With 3.83
Re: Fuse next to battery keeps blowing.
Does anyone have a pic of how there's is hooked up? Picks would help a lot!!
Thanks in advance
Thanks in advance
#5
Member
Thread Starter
Join Date: Jun 2014
Location: Ny queens
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 GTA Trans Am
Engine: 5.7 350 TPI
Transmission: TCI transmission
Axle/Gears: 4th gen rear end. With 3.83
Re: Fuse next to battery keeps blowing.
Also when the car does shut off I hear a loud squeaking noise from one of the relays on the firewall on the driver side
Any idea what that can be. Should I replace the relays?
#6
Senior Member
iTrader: (1)
Join Date: Dec 2012
Location: Tucson, AZ
Posts: 808
Likes: 0
Received 4 Likes
on
2 Posts
Car: 88 GTA Notchback
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: don't know
Re: Fuse next to battery keeps blowing.
That fuse is the Fuel pump / ECM battery fuse. If the relay is squeaking could be the reason the fuse is blowing. I would replace the relay and go from there.
#7
Member
Thread Starter
Join Date: Jun 2014
Location: Ny queens
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 GTA Trans Am
Engine: 5.7 350 TPI
Transmission: TCI transmission
Axle/Gears: 4th gen rear end. With 3.83
Re: Fuse next to battery keeps blowing.
Wouldn't a bad relay make the fuse blow right away or make the car not even start? Does autozone oar pepboys sell these relays?
Trending Topics
#8
Supreme Member
Join Date: Jun 2011
Location: knoxville tn
Posts: 2,036
Likes: 0
Received 5 Likes
on
5 Posts
Car: 86 IROC
Engine: 5.0 TPI
Transmission: 700-R-4
Axle/Gears: 2.73 open
Re: Fuse next to battery keeps blowing.
stay VERY far away fro both auto zone AND pep boys for your parts. go to NAPA or oreilleys. I have the GM part numbers for the relays ,should you want them. the fuse by the battery in a weather proof connecter is for the ECM main power . if it blows .you have a short somewhere.
#9
Supreme Member
Re: Fuse next to battery keeps blowing.
That fuse provides constant battery power to the fuel pump relay, fuel pump oil pressure switch, MAF relay, MAF burnoff relay, and ECM. Veaceonee said that the relay making the squeaking noise is a likely culprit and he's right. I would at least start my checking there. If it's not the relay itself, it is the circuit that that relay controls. My suspicion, next to relay being at fault would be the fuel pump or the fuel pump oil pressure switch. With the age of the car, it could also be wiring that is touching ground somewhere. Check all of the wiring from the noisy relay for short to ground. NAPA has the relays.
The reason that the fuse doesn't blow immediately when you start the car is probably because the draw is just at the limit of the fuse's capacity. The high draw heats the fuse until it finally breaks.
The reason that the fuse doesn't blow immediately when you start the car is probably because the draw is just at the limit of the fuse's capacity. The high draw heats the fuse until it finally breaks.
Thread
Thread Starter
Forum
Replies
Last Post