Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

No Power After First Start Up

Thread Tools
 
Search this Thread
 
Old Jul 6, 2009 | 12:14 PM
  #1  
86firebirdta's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2007
Posts: 582
Likes: 0
From: Manteca, Ca
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
No Power After First Start Up

I have a 1986 trans am 305 tpi been sittin for 5 months while i did a lil bit of tune up stuff for it and when i just get about to start it it only started to crank for a second then nothin no accessories or anything looked in my fuse box and nothin popped ima get under and look for a short or anything but any suggestions would be a help
Reply
Old Jul 6, 2009 | 12:28 PM
  #2  
89-bird's Avatar
Senior Member
15 Year Member
 
Joined: Mar 2009
Posts: 790
Likes: 0
From: Pigeon Forge ,TN
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

If it's sat for 5mths and not run I would charge the battery first and see if that does it cause a battery will discharge over time .
Reply
Old Jul 6, 2009 | 12:42 PM
  #3  
86firebirdta's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2007
Posts: 582
Likes: 0
From: Manteca, Ca
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

fully charged up the night before
Reply
Old Jul 6, 2009 | 12:45 PM
  #4  
89-bird's Avatar
Senior Member
15 Year Member
 
Joined: Mar 2009
Posts: 790
Likes: 0
From: Pigeon Forge ,TN
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

How are the connections at the battery and starter and the junction block ?
Reply
Old Jul 6, 2009 | 12:51 PM
  #5  
86firebirdta's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2007
Posts: 582
Likes: 0
From: Manteca, Ca
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

they are all nice and tight is it could i have my starter hooked up wrong and blew a relay or fuse
Reply
Old Jul 6, 2009 | 12:59 PM
  #6  
89-bird's Avatar
Senior Member
15 Year Member
 
Joined: Mar 2009
Posts: 790
Likes: 0
From: Pigeon Forge ,TN
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

Possibly , I would check to be safe .
Reply
Old Jul 6, 2009 | 02:22 PM
  #7  
86firebirdta's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2007
Posts: 582
Likes: 0
From: Manteca, Ca
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

is there a certain order that goes on the bigger bolt and which color goes on the smaller one jus wanna make for sure i got it right
Reply
Old Jul 6, 2009 | 02:29 PM
  #8  
89-bird's Avatar
Senior Member
15 Year Member
 
Joined: Mar 2009
Posts: 790
Likes: 0
From: Pigeon Forge ,TN
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

I believe it is purple for the small bolt on the solenoid and the others just go on the big bolt .
Reply
Old Jul 6, 2009 | 03:18 PM
  #9  
86firebirdta's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2007
Posts: 582
Likes: 0
From: Manteca, Ca
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

there is no certain order that they go on
Reply
Old Jul 7, 2009 | 12:02 AM
  #10  
Billy_Bob's Avatar
Junior Member
 
Joined: Jul 2009
Posts: 68
Likes: 0
From: Oregon
Car: 92 GMC Sierra 2500
Engine: 5.7l
Transmission: 4L70
Axle/Gears: GT4 3.73
Re: No Power After First Start Up

With a multimeter, test the battery voltage with the ignition on.

If the battery is good and you have a full charge, it should read 12 something volts with the ignition on. (Load on battery.)

Also you should be able to turn on your headlights and they should be bright without the engine running.

If you're not getting 12 volts with the ignition on and the headlights are dim when turned on, then there is a battery or other electrical problem.
Reply
Old Jul 7, 2009 | 09:23 PM
  #11  
86firebirdta's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2007
Posts: 582
Likes: 0
From: Manteca, Ca
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

it aint the battery is there a fusable link that would break that would make it so that no power would go thro my car...jus a thought
Reply
Old Jul 9, 2009 | 09:08 AM
  #12  
89-bird's Avatar
Senior Member
15 Year Member
 
Joined: Mar 2009
Posts: 790
Likes: 0
From: Pigeon Forge ,TN
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

There could be one comeing off the starter or one off your battery cable .
Reply
Old Jul 9, 2009 | 05:36 PM
  #13  
86firebirdta's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2007
Posts: 582
Likes: 0
From: Manteca, Ca
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

on my wire diagram i have two that cos off my battery one goes to the ignition switch first then the second goes to the generator
Reply
Old Jul 10, 2009 | 07:55 AM
  #14  
89-bird's Avatar
Senior Member
15 Year Member
 
Joined: Mar 2009
Posts: 790
Likes: 0
From: Pigeon Forge ,TN
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

Check those and see if there is anything wrong with them .
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Azrael91966669
DIY PROM
25
Jun 20, 2017 04:04 AM
Orr89RocZ
Power Adders
206
Apr 25, 2016 08:28 AM
mdtoren
TPI
12
Aug 23, 2015 12:52 PM
86White_T/A305
LTX and LSX
0
Aug 17, 2015 12:16 AM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM




All times are GMT -5. The time now is 03:35 AM.