I have a complete t-5 setup out of an 86 Iroc with just over 100k miles on it. Car was stock, not raced or abused. I have everything, trans bellhosing,shifter,clutch,flywheel,pedals,hydrolics,drive shaft, crossmember, all the bolts and the rubber boot that covers the hole in the floor.
GARUNTEED to be in good working condition. asking $500.
thanks
J
cyclerage23@yahoo.com

 

Dude, where are you located at???

 

I am in central NJ,08857

 

still have this ? e-mail me a # i can contact you at Gbodyolds@aol.com

 

Still have the drive shaft? If so will you sell just that?

 

Yes. $40+shipping

 

Sorry, a good deal if I didn't have to have it cut down 2" and re-balanced for an additional $90.

 

Why do you have to cut it? 6spd?

 

He wouldn't have to cut it for a 6sp. Must be something else.

 

Really? Stock D.shaft works? Thats good to know.

 

Wrong. I do have to cut it for my 6 spd. Approx. 2". I have an aftermarket T56 from spohn.

 

I wasn't aware that the aftermarket ones required the driveshaft to be shortened. I guess you learn something new every day. As for the 93-97 boxes, the driveshaft is the same as the 5-speed and the automatic, except for the 82 (maybe 83) automatics. I put the driveshaft out of my 5-speed car in my GTA when the u-joints went bad and that same shaft was in there with the 6-speed, until the LS1 aluminum shaft went in. What do you do for a torque arm with the aftermarket? Are you just stuck using an aftermarket (like Spohn) torque arm or is there a way to do it on the cheap? When I converted my car, I didn't want to drop the extra coin for an aftermarket torque arm, so I just re-used the stock one. About 1 year later, I got my aftermarket onet to take the pivot off of the rear extension housing of the tranny. Now all I have to do is install it.

 

Well, I have a stock 5 spd d.s. if you want to make an offer on it.

 

I slid the bushing back on the TQ arm 2" and cut off the excess. Now since I've busted my stock tq arm I'm using a Jegster that's shorter and bolts to the chassis.

85C4 - you have a PM.

 

Can I get some pics? dn483@yahoo.com Thanks David

 

THis set up is sold