Hi,
I have s10 axles that look to be 28 splines,,,,, are they the same as the camaro axles?? would they fit?

 

No.

They are exactly the same, except they're different. Different length.

If you have an axle stretcher though, I believe you can stretch them just barely enough to make them work.

 

lmao!

thats pretty much the same line we use on the newbies at work, If they make a hydraulic hose too short we tell them to go fing the hose stretcher, they spend a good half hour looking for it before we fill them in on whats going on!

 

lol... i am somewhat amused by threads like these. hehehehehe

 

Ask them to;

1) Go get a fallopian tube.

2) Go get me a bucket of bulkhead remover.

3) Go get a bucket of steam.

Then go ask the to get a chain stretcher (those are real).

 

If it was only that easy, all the S10 axles would have disappeared years ago. The only axles that will fit into a third gen housing are from another third gen or aftermarket axles. Aftermarket third gen 28 spline axles are only $125 - $150 each.

 

yah ok i have a 1 set of s10 28 spline axles and i have 2 sets of camaro 26 spline axles.....that sucks

ok so maybe ill just weld in 2 more splines on each axle and i should be good....noo wait ill just cut the ends of the s10 axles and put them on the camaro axles... what will work good. JK

Ok on a serious note why are the 28s better then the 26's anyhow??

 

They are a larger diameter axle. = stronger

 

ok yes that would do it... thanks!