Search: Posts Made By: nameinuse
Showing results 1 to 50 of 60
Search took 0.15 seconds.
07-21-2006, 09:01 AM
Replies: 1
Views: 350
Posted By nameinuse

Exhaust too close to the tank or fuel lines,maybe?

Exhaust too close to the tank or fuel lines,maybe?
07-01-2006, 05:18 PM
Replies: 9
Views: 618
Posted By nameinuse

https://www.thirdgen.org/forums/tech-general-engin...

https://www.thirdgen.org/forums/tech-general-engine/373584-need-help-egr-expert.html?highlight=diagnostic+solenoid
Post 8 has a picture that might help you.
06-27-2006, 10:08 AM
Replies: 11
Views: 573
Posted By nameinuse

My IAC is pretty noisy.Not sure if it is supposed...

My IAC is pretty noisy.Not sure if it is supposed to be that way.
Probably not,since the idle is pretty jumpy with ac on.:)
06-14-2006, 03:20 PM
Replies: 6
Views: 391
Posted By nameinuse

Same here,a little dribble from the left rear.

Same here,a little dribble from the left rear.
06-10-2006, 01:31 PM
Replies: 3
Views: 524
Posted By nameinuse

The last picture is the main vacuum source for...

The last picture is the main vacuum source for the cruise control and vent/ac controls.On my van that one is connected to a stud in the manifold aft of the throttle body and it has a check valve...
Forum: Cooling
06-09-2006, 08:23 PM
Replies: 6
Views: 1,518
Posted By nameinuse

You have two temp sensors on your car,the...

You have two temp sensors on your car,the CTS(Coolant Temperature Sensor,sends info to the computer) that sits on the intake right beside the thermostat housing.This one may or may not give a SES...
Forum: Cooling
06-08-2006, 11:01 AM
Replies: 7
Views: 691
Posted By nameinuse

Check all vacuum tubes and hoses under the hood...

Check all vacuum tubes and hoses under the hood before tearing down the controls.
My first van had that trouble for a while,it was simply a little white tube under the windscreen that had been...
05-26-2006, 05:14 PM
Replies: 4
Views: 379
Posted By nameinuse

On my van it feeds cruise and hvac.

On my van it feeds cruise and hvac.
05-25-2006, 03:13 AM
Replies: 8
Views: 14,561
Posted By nameinuse

Did you:Clean the bores,lubricate the o-rings,use...

Did you:Clean the bores,lubricate the o-rings,use new back up washers,put a new gasket under the metering lid after THOROUGH cleaning?
Forum: TBI
05-24-2006, 10:05 AM
Replies: 8
Views: 1,195
Posted By nameinuse

where did you mount the sender?

where did you mount the sender?
05-20-2006, 06:47 PM
Replies: 3
Views: 6,265
Posted By nameinuse

My valve cover gasket has a small leak,the oil...

My valve cover gasket has a small leak,the oil trickles down the block and ends up hanging from the filter.
Forum: TPI
05-20-2006, 05:48 PM
Replies: 15
Views: 648
Posted By nameinuse

It was a reply to Joe,who runs two valves.

It was a reply to Joe,who runs two valves.
Forum: TPI
05-20-2006, 05:38 PM
Replies: 15
Views: 648
Posted By nameinuse

One side,the one NOT connected to manifold...

One side,the one NOT connected to manifold vacuum, is supposed to be an open tube.
Forum: TBI
05-20-2006, 04:21 PM
Replies: 2
Views: 3,225
Posted By nameinuse

Blocked return line?

Blocked return line?
Forum: TBI
05-20-2006, 10:59 AM
Replies: 25
Views: 1,292
Posted By nameinuse

Some 800 SEK:D .Took two days at a really serene...

Some 800 SEK:D .Took two days at a really serene pace with a lot of coffee breaks,if I would do it again today it would take 4 hours tops.
Forum: TBI
05-20-2006, 02:20 AM
Replies: 25
Views: 1,292
Posted By nameinuse

Hansen Racing,Stockholm.Not much of a help to...

Hansen Racing,Stockholm.Not much of a help to you,I`m afraid.:)
Any decent parts shop in the US should have one,at about a third of the swedish prices or so.
Forum: TBI
05-19-2006, 11:42 PM
Replies: 25
Views: 1,292
Posted By nameinuse

I did a tb-rebuild 2 weeks ago,it`s not a...

I did a tb-rebuild 2 weeks ago,it`s not a complicated job.
Just buy a rebuild kit,take it apart,clean it well and assemble.
Take it easy when tightening the screws,aluminium threads are weak.
05-17-2006, 03:05 PM
Replies: 6
Views: 428
Posted By nameinuse

Never fiddled with a tpi motor,but the hose...

Never fiddled with a tpi motor,but the hose without a valve should be taking in air through the air filter,or vent gases that way when vacuum is low and crankcase pressure is high.
That hose should...
05-17-2006, 01:08 PM
Replies: 6
Views: 428
Posted By nameinuse

Any side will do,the line with the valve is...

Any side will do,the line with the valve is connected to to manifold vacuum and the other side goes to the air cleaner (in my case to the spacer ring between the tb and the aircleaner).
I simply...
05-17-2006, 12:29 PM
Replies: 6
Views: 428
Posted By nameinuse

Should be just one.My van had two,one in each...

Should be just one.My van had two,one in each valve cover,when I bought it.
Took me a while to figure out what looked so wrong.:)
05-17-2006, 12:16 PM
Replies: 2
Views: 383
Posted By nameinuse

The MAP sensor is expecting a change of manifold...

The MAP sensor is expecting a change of manifold pressure within a certain amount of time after an EGR command,I think.
05-13-2006, 03:30 PM
Replies: 12
Views: 415
Posted By nameinuse

After two years a little service would be good. ...

After two years a little service would be good.
Cap,rotor,plugs,wires,air filter,fuel filter,oil filter and oil is a start.
The pcv valve might be gooed up,and check all vac lines.
05-10-2006, 05:04 PM
Replies: 10
Views: 1,165
Posted By nameinuse

Not a very bright thing to do,since it may take...

Not a very bright thing to do,since it may take other wiring or flammable stuff with it.
Forum: Electronics
05-10-2006, 01:33 PM
Replies: 23
Views: 662
Posted By nameinuse

Wanted an extra for the stereo,but since there...

Wanted an extra for the stereo,but since there was room beside the subwoofer box for two batteries why not fill it?
Forum: Electronics
05-10-2006, 12:44 PM
Replies: 23
Views: 662
Posted By nameinuse

Yes,the + wire was pretty fat and drawn in an...

Yes,the + wire was pretty fat and drawn in an electrical conduit hose giving it some extra insulation and the hose was in turn isolated from the chassi.
Had a battery separator and fuses,but never...
Forum: Electronics
05-10-2006, 12:36 PM
Replies: 23
Views: 662
Posted By nameinuse

I had three batteries paralelled in a van I used...

I had three batteries paralelled in a van I used to own,ran it that way for over three years with no ill effects.
One was in the original spot,the other two were mounted about six feet rearward in a...
05-09-2006, 05:02 PM
Replies: 7
Views: 506
Posted By nameinuse

Why bother?US parts are pretty cheap.

Why bother?US parts are pretty cheap.
05-09-2006, 01:47 PM
Replies: 7
Views: 506
Posted By nameinuse

If you live around Stockholm:Hansen Racing,Nåkab...

If you live around Stockholm:Hansen Racing,Nåkab or Klintberg &Way should have one that fits.
05-09-2006, 10:10 AM
Replies: 1
Views: 403
Posted By nameinuse

Personally I would check connectors and wiring...

Personally I would check connectors and wiring first of all.
05-08-2006, 03:19 PM
Replies: 13
Views: 1,029
Posted By nameinuse

Are the limits the same,since there is a...

Are the limits the same,since there is a difference in displacement?
05-07-2006, 11:34 AM
Replies: 2
Views: 427
Posted By nameinuse

Filter?

Filter?
Forum: Cooling
05-06-2006, 11:46 AM
Replies: 48
Views: 1,791
Posted By nameinuse

Have you checked the voltage at the fan connector...

Have you checked the voltage at the fan connector with the fan running?
A voltage drop would make it spin slower,moving less air.
Forum: Cooling
05-05-2006, 08:51 AM
Replies: 48
Views: 1,791
Posted By nameinuse

Does "stock" mean "standard" or "1985 original,on...

Does "stock" mean "standard" or "1985 original,on car since new"?
05-02-2006, 12:24 PM
Replies: 17
Views: 5,511
Posted By nameinuse

Did you rotate the crank to it`s proper position...

Did you rotate the crank to it`s proper position between adjustments,or did you just adjust all of them with it in the same position?
Forum: Cooling
04-29-2006, 03:51 PM
Replies: 21
Views: 1,196
Posted By nameinuse

Try a new radiator cap,if it don`t keep adequate...

Try a new radiator cap,if it don`t keep adequate pressure the liquid will boil at 100*C.
When the circulation stops after shutdown,the temp can rise well above boiling at atmospheric pressure.
04-29-2006, 06:02 AM
Replies: 8
Views: 665
Posted By nameinuse

Daimler-Benz even used nitrous in some of their...

Daimler-Benz even used nitrous in some of their 600 engines,I think.
04-28-2006, 07:43 PM
Replies: 8
Views: 665
Posted By nameinuse

The main reason turbo compound engines...

The main reason turbo compound engines disappeared from aviation was the development of the mechanically simpler and more reliable jet engines,afaik.
But jet engines are not very practical in road...
04-23-2006, 10:57 AM
Replies: 4
Views: 310
Posted By nameinuse

My first step would be to disconnect,clean and...

My first step would be to disconnect,clean and inspect all connections at the starter.
Remember to disconnect the battery first.
Forum: Cooling
04-22-2006, 01:42 PM
Replies: 6
Views: 635
Posted By nameinuse

Does the fan in question work if you feed it 12v...

Does the fan in question work if you feed it 12v directly?
04-18-2006, 12:50 PM
Replies: 10
Views: 3,409
Posted By nameinuse

See the post above yours,one of his examples of...

See the post above yours,one of his examples of things going wrong was:
"Hot exhaust gasses entering the pump."
Those are check valves.
Forum: TBI
04-17-2006, 04:48 AM
Replies: 6
Views: 650
Posted By nameinuse

EGR too?

EGR too?
04-12-2006, 11:18 PM
Replies: 45
Views: 1,721
Posted By nameinuse

Take the starter out,open it up and look inside. ...

Take the starter out,open it up and look inside.
ANY sign of contact between rotor and stator is bad.
It could also be an internal short in the coils,but that`s not necessarily visible and you need...
04-12-2006, 03:56 PM
Replies: 23
Views: 1,730
Posted By nameinuse

A sturdy one with a gasket that seals good? A...

A sturdy one with a gasket that seals good?
A big enough leak here can set the "Manifold Absolute Pressure too high" (don`t have the book handy) code and render the car totally undriveable.
A small...
04-11-2006, 10:10 AM
Replies: 23
Views: 1,730
Posted By nameinuse

How is it blocked off?

How is it blocked off?
04-10-2006, 11:43 PM
Replies: 45
Views: 1,721
Posted By nameinuse

The heat is a result of too much current and too...

The heat is a result of too much current and too little copper.
Either the wire is too thin or the starter draws way too much current,since the wiring heats up in seconds.
An electric motor can...
04-10-2006, 12:20 PM
Replies: 45
Views: 1,721
Posted By nameinuse

If you have the battery mounted a good distance...

If you have the battery mounted a good distance away from the starter,how thick is the wire?
Sounds like a major voltage drop there.
03-12-2006, 08:31 AM
Replies: 8
Views: 667
Posted By nameinuse

Remove the belt and turn the generator by hand,if...

Remove the belt and turn the generator by hand,if there is any bad sounds or obvious play in the bearings it`s time to buy a new one.
Also check the voltage,does it go down if you rev the motor?
Forum: Cooling
03-11-2006, 05:17 AM
Replies: 59
Views: 2,426
Posted By nameinuse

Note to self: Posting before reading the last...

Note to self:
Posting before reading the last post is unwise and a waste of time.
Forum: TBI
02-23-2006, 12:38 PM
Replies: 18
Views: 1,300
Posted By nameinuse

Working indoors can be a real treat during winter...

Working indoors can be a real treat during winter or heavy rain.:)
12-29-2005, 10:21 AM
Showing results 1 to 50 of 60
 


 
Forum Jump


All times are GMT -5. The time now is 06:47 AM.