first of all i want to say im sorry for my spelling its not my best subject

ok when i turn on my left signel my back one flashs but not my frount i tryed the other side and get both frount right and rear right to flash the frount left lights up when the park lights are on so its not a bad balb any one know how to fix this problemi thanks in advance

 

Yes, sounds like a bad bulb. You can replace it easily, it's a standard dual filament bulb available at any car parts store (you should probably carry one or two in the trunk).

You can turn on a spellchecker in your browser, they help a lot.

Lou

 

i went out and bought 2 new bulbs and it still will not flash. any idea what it could be?

 

Grab a test light, remove the lightbulb and test for 12V signal (interrupted) inside the socket with the turn signal on. If you don't get 12V inside the socket, follow the wires, it's the blue wire, not the brown one.

Let us know what you find.
Lou

P.S.: If the turn signal indicator in the dash doesn't flash and if even the front fender side marker doesn't flash, it could be the steering column switch. In that case you can check for 12V on the light blue wire on the flat multi-function switch connector on the bottom of the steering column.

 

i took my multi meader and ohmed out my socket i was getting tone on all 3 medal tabs am i sapost to get that or is it grounded out

 

Do not measure resistance, measure voltage with the turn signal on. Resistance measurement will not give you any good results because you are measuring a circuit with other bulbs connected with a drain to ground.
A test light is actually better than a digital voltmeter (instant) but if the meter is the only thing you have, you just have to watch it very closely for 12V pulses.

Lou

 

i wasnt getting any type of voltage what so ever when i was useing my meter

 

No voltage but your meter beeped when you were measuring continuity? That sure is strange.
Trace the blue wire and keep probing it until you find 12V on it (with the turn signal flashing).

Lou

 

went out today and tested the turn signal switch and wasnt getting voltage on the light blue wire and noticed that my left indacator light wasnt flashing eather so im saying my turn signal switch is bad and needs replaced

 

Before diving into the whole steering column, I suggest removing the driver side knee panel and testing the flat multi-function switch connector.
With the left turn signal on, put a test light on the light blue wire to detect voltage. (dark blue is the right front, dark green is the right rear, yellow is the left rear).

THat will tell you for sure whether the switch is bad or not.

Lou

 

thats what i tested when i did the test and wasnt getting any voltage on the light blue wire going into connector

 

Alright, that sounds like a pretty good conclusion.
The switch normally costs $25 or so at a car parts store, usually readily available.

Lou

 

went and got my new switch and a new key ignation do to my old one finly gave out will let you all know what the out come was

 

We carry nice turn signal switches for these cars.Just in case anyone else has one go bad we stock them,pretty common in these cars.

T

Turn Signal Switch

 

yup it was the turn switch when i puled the old one out the wire for the frount right signel was broke

 

Thanks for posting your solution. It helps other members when they read your thread.

Btw

Lou