91 Camaro won’t start
91 Camaro won’t start
Anybody can explain step by step how to completely remove VATS I think that may be what’s causing my car not to start and I noticed it has a aftermarket alarm I want to remove that as well
i have no need for a Alarm on my vehicle PERIOD
Thanks
i have no need for a Alarm on my vehicle PERIOD
Thanks
Joined: May 2015
Posts: 674
Likes: 23
From: Ohio
Car: 92 RS / 90 IROC-Z
Engine: 305 / 350
Transmission: Auto
Axle/Gears: Non-Posi / Posi - Both GU2 - 2.73
Re: 91 Camaro won’t start
Last edited by 92RS-HeritageEd; Mar 1, 2019 at 05:00 PM.
Re: 91 Camaro won’t start
Turns out the Battery is Toast even after I had it charged up at autozone it still died on me...I didn’t see a security light on in the dash when I turn the key it does not crank or do anything
Re: 91 Camaro won’t start
I just want any Useless electronics removed from the car I never trusted aftermarket alarms ...I’m not doing the work myself I want a shop to remove any pieces of alarm system in the car
Joined: May 2015
Posts: 674
Likes: 23
From: Ohio
Car: 92 RS / 90 IROC-Z
Engine: 305 / 350
Transmission: Auto
Axle/Gears: Non-Posi / Posi - Both GU2 - 2.73
Re: 91 Camaro won’t start
When you have a Known Good or Known Charged battery pay attention when your turning the key to the 1st position (Run Position) you should have LEDs for BRAKE, INFL RESET, and SECURITY light up I know for sure... INFL will remain lit if there's an Airbag issue, BRAKE will remain lit if the E-Brake is engaged and SECURITY should come on for about 2-3 seconds and go off if the VATS system is operational. If it truly "does not crank or do anything" then my friend revisit that battery situation first.
Last edited by 92RS-HeritageEd; Mar 1, 2019 at 05:23 PM.
Trending Topics
Joined: Dec 2004
Posts: 16,734
Likes: 993
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: 91 Camaro won’t start
Have you tried to jumper the starter enable relay?
or atleast check for power when you turn the key to crank position.
or atleast check for power when you turn the key to crank position.
Joined: Dec 2004
Posts: 16,734
Likes: 993
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: 91 Camaro won’t start
When I turn the key to the on position I just see a brake light a INFL light and the temperature gauge needle goes all the way to the end ...I got Headlights dashlights everything works...just no crank no start
Joined: Dec 2004
Posts: 16,734
Likes: 993
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: 91 Camaro won’t start
A volt ohm meter or test light are very cheap. You can make a jumper to bypass the relay the two larger gauge wires get jumpered together. Of while trying to crank the car over check for power at the yellow or green wire. If you have power there vats is the issue and needs to be fixed or bypassed in one of the ways mentioned in the link I posted.
Thread
Thread Starter
Forum
Replies
Last Post
JTNKTZ
Tech / General Engine
24
Jun 18, 2010 12:20 PM
Free Bird
Tech / General Engine
6
Feb 15, 2005 01:11 PM









