Tech / General Engine - Page 1131 - Third Generation F-Body Message Boards

New Thread Subscribe

Filters

Page 1131 of 2016

1131

Threads in Forum: Tech / General Engine

Forum Tools Search this Forum

Thread / Thread Starter

Last Post

Replies

Views

18, 1991, 416, arm, cylinder, head, heads, identification, l03, lo3, ported, rocker, rs

416 heads for L03

91RockS on Oct 22, 2004

Oct 27, 2004 09:01 PM
by 91RockS

1,726

what will i make

ridecamro on Oct 25, 2004

Oct 27, 2004 07:32 PM
by Streetiron85

514

Those who perform visual inspections...

Farfire70 on Oct 27, 2004

Oct 27, 2004 06:13 PM
by five7kid

580

were can i find the specs on my head

ridecamro on Oct 27, 2004

Oct 27, 2004 05:40 PM
by RB83L69

497

HELP! how do I post pics?

leeperryracing on Oct 27, 2004

Oct 27, 2004 04:48 PM
by ME Leigh

415

LT1 startup

Blake on Oct 27, 2004

Oct 27, 2004 04:02 PM
by sellmanb

400

Looking for some advice and suggestions.

89IROCZTPI on Oct 23, 2004

Oct 27, 2004 03:46 PM
by 89IROCZTPI

674

roller rockers

Scania on Oct 23, 2004

Oct 27, 2004 02:58 PM
by pasky

964

Heads rolled to 21°, good, bad or ugly?

a73camaro on Oct 25, 2004

Oct 27, 2004 11:45 AM
by a73camaro

531

87, cable, firebird, hooking, speedometer

speedometer cable Q

twobirds on Oct 26, 2004

Oct 27, 2004 08:43 AM
by twobirds

497

Please answer these simple questions for me fast!! (Not simple to me obviously.)

PneumaticTire on Sep 15, 2004

Oct 27, 2004 01:36 AM
by Air_Adam

717

383, bolt, filing, flange, head, header, headers, hedman, hole, iroc, l98, leak, leaking, stop

Header's leaking...

dj haf on Oct 20, 2004

Oct 26, 2004 11:18 PM
by Air_Adam

2,000

250, big, block, car, damage, do, hours, iroc, l98, left, overheat, overheated, overheating, running, temp

Temp hit 250 yesterday! Did i do any long term damage?

CAMAROsc350 on Oct 25, 2004

Oct 26, 2004 09:20 PM
by CAMAROsc350

3,557

engine question

trans_am_ta_84 on Oct 25, 2004

Oct 26, 2004 09:02 PM
by REALPOWER

491

350, 85, block, cams, comp, conversion, converting, gen, kit, lifter, lifters, older, put, roller, small, stock, v6

Roller lifter conversion for older block.

F-1Rodder on Oct 26, 2004

Oct 26, 2004 08:17 PM
by RB83L69

1,075

Need help fast!!

Baylisstic12 on Oct 25, 2004

Oct 26, 2004 07:49 PM
by a73camaro

495

1997, 87, camaro, changing, comaro, coolant, irocz, pump, replacement, replacing, sensor, temp, trans, water, waterpump

Replacing Waterpump...

MasterEvilAce on Oct 24, 2004

Oct 26, 2004 07:48 PM
by MasterEvilAce

16,448

lt1 build

TheViper on Oct 25, 2004

Oct 26, 2004 06:50 PM
by sellmanb

506

Heater core hoses....

86iroclamarque on Oct 26, 2004

Oct 26, 2004 06:12 PM
by thirdgen88

926

190, 1987, 305, block, engine, front, lb9, machine, motor, numbers, sfd, tpi

Numbers on the front of a Engine Block

okfoz on Oct 26, 2004

Oct 26, 2004 06:03 PM
by ME Leigh

1,129

what do i need to make my fuel pressure gauge work?

TraviZ on Oct 16, 2004

Oct 26, 2004 05:33 PM
by ChevelleFan

722

a557, distripeter, drop, mark, set, timing

rookie timing questions...

RedWagon42 on Oct 25, 2004

Oct 26, 2004 05:28 PM
by Air_Adam

492

Deleting heater core

galletti on Oct 26, 2004

Oct 26, 2004 05:12 PM
by Air_Adam

460

2000, car, firebird, lights, loses, pontiac, power, stalls, starts, v6

89 V6 bird loses power randomly

firebirdjosh on Oct 24, 2004

Oct 26, 2004 04:48 PM
by Naft

466

Unplugged MAP

bulletboy29 on Oct 25, 2004

Oct 26, 2004 04:06 PM
by 1981TTA

551

Got offered insane amount for my motor with tpi, how hard would it be to go carbed?

Cameron on Oct 25, 2004

Oct 26, 2004 02:59 PM
by RB83L69

585

Hate myself for loving this car!!! Need timing help!

bulletboy29 on Oct 26, 2004

Oct 26, 2004 02:44 PM
by 86z/92rs

498

aviation, bolt, bolts, equivalent, freeze, gasket, head, headbolts, indian, permatex, plugs, remove, sealant, shellac, threads, torquing

Using Permatex "Indian Head" to seal head bolts?

blue86iroc on Oct 26, 2004

Oct 26, 2004 12:52 PM
by ede

14,870

383, 43167, craftsman, diameter, distribor, distributer, distributor, engine, miniture, pin, punch, remove, roll, set, ways

How to remove pin from distributor

RaCeCaRdRiVa on Oct 25, 2004

Oct 26, 2004 12:44 PM
by RaCeCaRdRiVa

3,571

305, car, dies, fluctuates, gauge, idle, lo3, make, oil, pessure, pressure, rough, run, sending, sensor, unit

LO3 oil pressure fluctuates and idles rough

92RSFivePointSlow on Oct 22, 2004

Oct 26, 2004 11:53 AM
by philoldsmobile

1,303

car, engine, support, supporting, thirdgen, tranny

Supporting Engine while tranny is out.

Ryknow86 on Oct 25, 2004

Oct 26, 2004 11:20 AM
by 88IROC350TPI

561

How many miles have you put on aluminum rockers?

86z/92rs on Oct 25, 2004

Oct 26, 2004 10:34 AM
by Cameron

561

a/c removal tech article...

krazycracka55 on Oct 25, 2004

Oct 26, 2004 10:18 AM
by krazycracka55

684

accel, car, crack, cracked, cracks, dimple, distributor, gear, gm, holofex, image, installing, magnet, magnetic, pickup, piece, shaped, star, switch, wheel

crack in distributor piece

kolkane on Oct 15, 2004

Oct 26, 2004 09:55 AM
by RB83L69

11,186

305, 88, diy, heads, home, intake, it, ls6, lt1, place, polish, polished, polishing, port, ported, porting, trans, worth

Home porting...what about polishing

DuronClocker on Oct 25, 2004

Oct 26, 2004 02:42 AM
by Sitting Bull

842

Vader Please Help

GTA350VORTEC on Oct 23, 2004

Oct 26, 2004 02:31 AM
by Chickenman35

748

350, 97, car, carb, convert, gen, hei, lt1, motor, newer

convert LT1 to non electronics

TheViper on Oct 25, 2004

Oct 25, 2004 11:23 PM
by Streetiron85

1,157

oil filter bypass?

thunderstick on Oct 24, 2004

Oct 25, 2004 10:47 PM
by TheMysticWizard

579

Your thoughts on my 383 build???

88IROK on Oct 25, 2004

Oct 25, 2004 09:49 PM
by 88IROK

643

Ignition module??

FBird84 on Oct 17, 2004

Oct 25, 2004 09:49 PM
by TheMysticWizard

846

car, coil, eeeee, high, lt1, makes, making, module, noise, pitched, whine

an eeeee sound

ralpax on Oct 24, 2004

Oct 25, 2004 09:26 PM
by ralpax

1,004

best heads for 800 or so dollars? (L98)

speedingpenguin on Oct 17, 2004

Oct 25, 2004 09:17 PM
by ME Leigh

985

Lt1 intake w/ MRG 5820 gaskets

N8MAN1068 on Oct 25, 2004

Oct 25, 2004 08:58 PM
by N8MAN1068

378

Running in 4 cylinders!!!

Davidgou on Oct 25, 2004

Oct 25, 2004 08:51 PM
by Davidgou

598

Waterpump coolant bypass blockoff question

Streetiron85 on Oct 25, 2004

Oct 25, 2004 08:33 PM
by 91banditt2

548

low/rough idle and dies

Chris Williams on Oct 22, 2004

Oct 25, 2004 08:05 PM
by ploegi

635

need emmission help

1982z28 on Oct 23, 2004

Oct 25, 2004 04:15 PM
by 1982z28

573

Transmisson? Speedo, rephrased a little

1986T&A on Oct 25, 2004

Oct 25, 2004 04:11 PM
by 1986T&A

317

MY CAR WONT START 89 TPi

GTA350VORTEC on Oct 24, 2004

Oct 25, 2004 03:41 PM
by GTA350VORTEC

578

240sx, car, emission, emissions, failed, failing, gas, great, nissan, nox, problems, runs, test, tests, texas

failed emissions nox test in texas Help!!!!

TEXASPLANOBOY on Oct 20, 2004

Oct 25, 2004 02:26 PM
by dual_88s

1,181